Download Print this page

H2oLabs 300CG Instruction Manual

One gallon glass carafe

Advertisement

Quick Links

One Gallon Glass Carafe
Instruction Manual
H2oLabs Model 300CG
© 2013 H2oLabs, Ltd.
10-07-11

Advertisement

loading

Summary of Contents for H2oLabs 300CG

  • Page 1 One Gallon Glass Carafe Instruction Manual H2oLabs Model 300CG © 2013 H2oLabs, Ltd. 10-07-11...
  • Page 2 SAFETY INSTRUCTIONS - Read Before Assembly ▲CAUTION: Always handle the glass Carafe with care to avoid breakage and possible injury. ▲Discontinue use of the Carafe if it is cracked or chipped. Ordinary imperfections in the glass such as bubbles, are completely normal and not a cause for concern.
  • Page 3 CARAFE ASSEMBLY INSTRUCTIONS Only tool required: Phillips (Cross-Head) Screwdriver, (not included) Note: Please use caution when handling the glass Carafe. 1. Remove all parts from the protective Styrofoam. Do not assemble if the Carafe is cracked or chipped. 2. Check Styrofoam packaging to locate all parts as specified below: Handle Handle Cover Nozzle with Glass Insert, (Activated Carbon Sachet Housing)
  • Page 4 3. Use the Styrofoam as an assembly platform. Place the Carafe spout facing down and the screws facing up. 4. Remove the screws and peel off the blue protective film from the stainless steel straps. 5. Align the right-hand side of the screw holes to the black reference line on the Carafe.
  • Page 5 7. Insert the top screw first using a Phillips, (cross-head), screwdriver. Turn the screw until barely snug. Do not tighten yet. 8. Insert the lower screw next and turn it till barely snug. Move the handle to the right a little so that the black reference line is just covered evenly by the handle edge.
  • Page 6 11. Clip the Handle Cover onto the Handle. Push it all the way in. 12. Wash the Carafe thoroughly prior to use with a couple drops of dish soap and warm water and rinse well. Place the lid on the Carafe with the opening facing the spout.
  • Page 7 NOZZLE AND GLASS INSERT 1. Carefully remove the Glass Insert from the Nozzle and gently wash, rinse and dry both parts. (It may be helpful to use a small flat head screwdriver to release the retaining tab.) Reinsert the Glass Insert back into the Nozzle.
  • Page 8 To order Activated Carbon Sachets, Cleaning Crystals, parts and accessories, or for information on High Capacity Automatic Units and other helpful products or information ... Visit www.H2oLabs.com or Call 1-800-990-3560 (Monday through Friday 8:00 AM to 5:00 PM Central time.)