Table of Contents
Advertisement
Removing the power supply
To remove the power supply:
1.
Use the Phillips screwdriver to unfasten the captive screw on the power supply.
Hold the captive screw and pull out the handle of the power supply.
2.
3.
As shown in
Figure
it out a little, support the bottom of the power supply with the other hand, and then
pull the module slowly along the guide rails out of the slot.
Figure 7 Removing the power supply
4.
Put the power supply on an antistatic mat.
5.
Install the blank panel back to the power supply slot, and fasten the captive screws.
CAUTION:
Before you insert a removed power supply into a power supply slot, make sure that
the LEDs on the power supply are both off.
7, grasp the handle of the power supply with one hand and pull
10
Advertisement
Table of Contents
