Download Print this page

Hasbro Chow Crown Quick Start Manual page 2

Advertisement

It's better not to wear bulky clothing (like a hoodie) or have your hair up.
1
Before you put on the crown, adjust the
Head Strap to about the size of your head.
Then pull the crown down so the front
padding rests against your forehead.
1
Have another player insert each of the Crown Arms into the Arm
Holder, and then load the Forks with snacks.
Stand up! Have another player press the PLAY/STOP button
1.
to select the game mode. Press quickly for a short game or
hold for a longer game.
2.
After you select a mode, the crown will start to spin and
play music. The challenge begins!
3.
Bite off the snacks...if you can! Remember, no using your
hands. Try to eat them all before the music stops.
When the song ends, your turn is over. Count how many
4.
snacks you ate. Be sure to remove any leftover food and
wash the Forks between turns!
5.
Pass the crown to any player who hasn't gone yet.
Now it's their turn.
Whoever ate the most snacks WINS!
E24200000 I Chow Crown.indd 2
PUT ON THE CROWN
Who's the hungriest? You go first!
2
3
Pull the Head Strap down over the back
of your head. You want a snug fit, but not
too tight.
LOAD THE SNACKS
2
Adjust the length and tilt the Forks so they reach your mouth.
PLAY
TASTY TIPS
• When passing the crown between turns,
remove the Crown Arms by lifting up the
Arm Holder and setting it upside down.
CLEAN UP
When you're done playing, throw away (or eat) any leftover food. Detach the Crown
Arms, Forks, Fork Arms, Arm Holder, Crown Front, and Crown Back from the Base.
Wash the Forks and make sure they are clean and dry before putting the game away.
ALKALINE BATTERIES REQUIRED
ALKALINE BATTERIES REQUIRED
NOT INCLUDED
NOT INCLUDED
IMPORTANT: BATTERY INFORMATION
1. TO AVOID BATTERY LEAKAGE
Shake your head up and down, side to side.
Take it off, tighten
Did the crown fall off?
the Head Strap, and try again.
2. Should this product cause, or be affected by, local electrical interference,
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy, and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• When putting the crown down, secure
Reorient or relocate the receiving antenna.
the Fork Arms to the upper parts of
Increase the separation between the equipment and receiver.
the Crown Arms.
Consult the dealer or an experienced radio/TV technician for help.
Caution: Changes or modifications to this unit not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
CAN ICES-3 (B) / NMB-3 (B)
© 2017 Hasbro, Pawtucket, RI 02861-1059 USA.
All Rights Reserved. TM & ® denote U.S. Trademarks.
Consumer contact:
USA and Canada:
Hasbro Games, Consumer Affairs Dept., P.O. Box 200, Pawtucket, RI 02861-1059 USA. TEL. 800-255-5516.
Australia consumer service: auconsumercare@ap.hasbro.com
New Zealand consumer service: nzconsumercare@hasbro.com
x3
TO INSERT BATTERIES
1.5V AA
Use a Phillips/cross head
screwdriver (not included).
CAUTION:
a. Always follow the instructions carefully. Use only
batteries specified and be sure to insert them correctly
by matching the + and – polarity markings.
b. Do not mix old batteries and new batteries or standard
(carbon-zinc) with alkaline batteries.
c. Remove exhausted or dead batteries from the product.
d. Remove batteries if product is not to be played with
for a long time.
e. Do not short-circuit the supply terminals.
f. RECHARGEABLE BATTERIES: Do not mix these with any other
types of batteries.
Always remove from the product before recharging. Recharge batteries
under adult supervision. DO NOT RECHARGE OTHER TYPES OF BATTERIES.
move it away from other electrical equipment. Reset (switching off and back
on again or removing and re-inserting batteries) if necessary.
4/11/18 4:03 PM

Advertisement

loading

This manual is also suitable for:

E2420