Advertisement
12. Use the chart below to determine the amount of
spacers that need to be positioned below the side plate
mounting flanges to attain the desired height-of-cut.
Rear Roller
Height-of-Cut (mm)
Spacers
0
9.5 to 11.9 mm
1
>11.9 to 14.3 mm
2
>14.3 to 16.7 mm
3
>16.7 to 19.1 mm
4
>19.1 mm
13. Using the screws, included in the kit, install the rear
roller brackets and the required amount of spacers to
the under side of the side plate mounting flanges.
14. Install the remaining spacers onto the screws above
the side plate mounting flanges and secure with the
supplied nuts.
15. Adjust to the desired height of cut and tighten the
height-of-cut arm mounting fasteners.
Note: As the reel wears, the standard height-of-cut
arms may need to be installed to attain desired height
of cut.
Height-of-Cut
(inches)
0.375 to 0.469 inches
0.469 to 0.563 inches
0.563 to 0.656 inches
0.656 to 0.750 inches
0.750 inches
2
Advertisement
