Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for djpower TOPCAT H-X3 DMX
- Page 1 H-X3 DMX Automatic Dry Ice Machine USE MANUAL...
-
Page 2: Before You Begin
Disclaimer The information and specifications contained in this User Manual are subject to change without notice. DJPOWER assumes no responsibility or liability for any errors or omissions and reserves the right to revise or to create this manual at any time. -
Page 3: Personal Safety
• Do not store dry ice in a sealed container to avoid explosion due to accumulated pressure. • Do not cover or block the nozzle during operation to avoid explosion due to accumulated pressure.。 • Be sure to wear protective gloves and do not directly touch dry ice with bare hands. •... -
Page 4: Product Overview
• The fog output carries moisture, please avoid the access to electrical equipment, power outlets and any places that may cause danger through moisture. • Never carry the product by the power cord or any moving part. Always use the handles. •... -
Page 5: Product Dimensions
Product Dimensions - 4 -... -
Page 6: Technical Specifications
2.5 TECHNICAL SPECIFICATIONS AC Power Input Voltage & Rate AC 220-240 V, 50/60 Hz; AC 110-120 V, 50/60 Hz Current Limiter Type Breaker Current Limiter Specifications 15A, 250V X 2 Typical Operating Current（230V） 26.1 A Heating Total Power 6,000 W Main Power 3,000 W Auxiliary Power... -
Page 7: Operation
AC Plug The H-X3 comes with a power input cord terminated with a Lockable power connector on one end. The other end is • CN plug (CN market, etc.) • EU plug (EU market, etc.) • US plug (US market, etc.) If the power input cord that came with your product has no plug, or if you need the change the plug, use the table below to wire the new plug: Connection... - Page 8 • When the power is OFF, open the upper cover to add water till the recommended level as shown in the right picture. Water Tank capacity is Appr. 32L. • Always connect the product to a grounded circuit. Before power on, make sure it is connected with the rated voltage. •...
- Page 9 4.2.1 Menu Map Display Description Parameter Range In case the water level is normal, this page appears when it Heating Up is heating. (Note: The machine can work after the water temperature reaches 40 ℃) Temp 65℃ Press <ENTER> / <STOP> at any time to return to this standby page.
-
Page 10: Dmx Mode & Operation
Press ▲/ <VOLUME> to start the continuous setting. Press ▲ and ▼ button to set the volume between 10% and 100%. Volume Working Status 100% 10% -100% Page Press <ENTER> / <STOP> at any time to return to the standby page. Screen flashes;... -
Page 11: Technical Information
4.4.1 DMX Working Page DMX Address Pressing “▲”or “▼“ to set the DMX starting address 1 - 512 When setting the DMX starting address, the number of channels occupied by the DMX mode Standby and must be considered. If the starting address is too high, some channels may not be controlled. setup page In DMX mode, each machine responds to the control of the DMX controller through its own unique starting address.
Need help?
Do you have a question about the TOPCAT H-X3 DMX and is the answer not in the manual?
Questions and answers