Advertisement
EEZ READER: Y157 CHRYSLER
DOUBLE-SIDED LOCK
INSTRUCTIONS
Fits The Following Chryslers:
(So Far)
All Chrysler Products 1994+
(Excluding Avenger, Sebring Coupe, and other Mitsubishi products.)
1. Prepare the lock by flushing the lock with a degreaser. Exercise
the wafers by inserting blank in and out of lock several times.
2. Put EEZ READER together, the slide and the key tool.
3. It is recommended
that you start reading
from the rear of the
lock and work your
way out towards the
face cap. It is also
important to cut the
key accordingly.
Remember that the door, deck and ignition locks are double-sided.
You will trap and read one side and then turn the tool over and
Advertisement
Table of Contents
Summary of Contents for EEZ Y157
- Page 1 1. Prepare the lock by flushing the lock with a degreaser. Exercise the wafers by inserting blank in and out of lock several times. 2. Put EEZ READER together, the slide and the key tool. 3. It is recommended that you start reading...
- Page 2 If you are reading the ignition lock with the trap slot pointing up, the EEZ Y157 has four lines on it that will line up with the ignition scalp. The other side of the tool has three line that will line up with the ignition scalp with the trap slot pointing downward.
- Page 3 8. Repeat the procedures 4 through 7 until you have read all the wafers. Remember to read both sides of the lock by turning over the tool. Please refer to the diagram below on wafer positions. EEZ Y157 DOUBLE-SIDED CHRYSLER...
Need help?
Do you have a question about the Y157 and is the answer not in the manual?
Questions and answers