Table of Contents
Advertisement
Quick Links
The firmware update of the EPOS FlashExtractor is supported in devices, produced
after May 1 2013 and equipped with an additional USB Update Adapter.
USB Update Adapter
The current firmware version is available at the device's page at the manufacturer's
site (www.epos.ua, section "Our solutions").
There you can also get the firmware update utility (PIC24H User Programmator.exe)
and the driver for the USB Update Adapter (FTDI VCP Driver).
Firmware update process:
1. Turn the device off (if it was on);
2. Start the firmware update utility "PIC 24H User Programmator";
Note: If the firmware update utility is started after the device is turned on, the
update will be impossible.
EPOS FlashExtractor
Firmware update manual
EPOS FlashExtractor with the adapter
1
Advertisement
Table of Contents
Related Manuals for EPOS FlashExtractor
Summary of Contents for EPOS FlashExtractor
- Page 1 EPOS FlashExtractor Firmware update manual The firmware update of the EPOS FlashExtractor is supported in devices, produced after May 1 2013 and equipped with an additional USB Update Adapter. USB Update Adapter EPOS FlashExtractor with the adapter The current firmware version is available at the device’s page at the manufacturer’s site (www.epos.ua, section "Our solutions").
- Page 2 3. Connect the USB Update Adapter to the device and then connect it to a PC via USB cable; 4. Turn the device on and wait for the diagnostic message "Devices setup completed" (Установка устройств завершена). The device information should appear in the program window;...
- Page 3 8. Completion of the firmware update (programming) is indicated by the progress bar and a corresponding diagnostic message (Отключите питание устройства, отключите кабель USB и включите питание устройства). After that, it is necessary to close the firmware update utility, turn the device off and disconnect the USB cable.
Need help?
Do you have a question about the FlashExtractor and is the answer not in the manual?
Questions and answers