Summary of Contents for FlexPro EEH/18
- Page 1 Water to water heating system User's manual EEH/18 Single compressor system: PCB revision: 248053 LCD revision: 248055...
- Page 2 Part 1: Operating panel introduction 1. Display interface This is for only hot water working mode. P2/Total14...
- Page 3 This is for hot water + heating working mode (optional). P3/Total14...
- Page 4 2. Buttons function ↓ ↓ ↓ ↓ ↓ Clock power 2.1 “Power” button ● Under unlock state, press this button for 1second, can turn on and turn off heat pump. ● Under other state, press this button, can return main interface. ●...
- Page 5 3. Operating 3.1 Parameters query and setting ①Working status parameters query press “M” button, How to enter? Under main interface, can enter working status parameters query interface. Working status parameters (table 1) Code Meaning No code Water tank temp Evaporating temperature Inlet gas temperature of compressor Outlet gas temperature of...
- Page 6 Error code (table2) Error code Meaning Er01 Wrong phase error Lack phase error Er02 Water flow switch error of using side Er03 Outlet gas pressure of compressor is too high error Er05 Inlet gas pressure of compressor is too low error Er06 Communication error Er09...
- Page 7 ②User parameters query and setting (both ON and OFF state can set) How to enter? ◆ Under main interface, press “M” for 3seconds, enter user parameter query interface, then press “+”and “-“ button , can query L2 to L9 value ◆...
- Page 8 is allowed to start Reserved Reserved 0（0: will not 0～40A Compressor current detect current） Reserved 3.2 Other operation ①Clock setting ◆ At main interface, press “clock” button for 5 seconds, enter clock setting interface ◆ At clock interface, press “clock” button, then “hour” flash, press “+”or “-”button，can set hour.
- Page 9 ◆ When group 1 ON timer flashing, press “clock” button, enter group 1 ON timer “hour” setting interface, “hour” flash, then press “+”or“-”button，then can set “hour” for group 1 ON timer. ◆ After finish setting “hour”, press “clock” button, then “minute” flash, then press “+”or“-”button，can set “minute”...
- Page 10 ④Remove history error code At the interface of query history error code, press “power” and “M” button together for 5seconds, can remove all the history error code. ⑤One-click restore function Under power off status, press “power” and “-“button together for 5seconds, can restore factory setting.
- Page 11 Electric connection / Wiring diagram P11/Total14...
- Page 12 Water connection The EEH/18 is mono-bloc design. You only need to connect water pipes as shown below. P12/Total14...
-
Page 13: Warranty Card
Warranty card Bar code： Product model： Buyer Address Invoice Date Repair Repair record Repairer Date P13/Total14... -
Page 14: Warranty Terms
Warranty terms 1. The warranty period is about 36 months from ex-work date writing on the unit. If any quality problem occurs, we will provide assistance, spare part(s) including shipping free of charge during the warranty period. We will keep providing assistance after the end of warranty, only spare parts and shipping will be charged to the customer.