Advertisement
Installation
1 Attach the TEMPLATE on the CEILING BOARD and drill a guided hole.
4 Fix the ANCHOR BOLT onto the concrete CEILING, and secure the SAFETY WIRE to the
ANCHOR BOLT as below:
1.
Tighten the NUT ("N1") on the ANCHOR BOLT.
2.
Insert the SAFETY BRACKET into the ANCHOR BOLT.
3.
Tighten two NUTs ("N2", " N3") onto the ANCHOR BOLT.
4.
Hook and fix one end of the SAFETY WIRE onto the SAFETY BRACKET.
5.
Hook and fix the other end of SAFETY WIRE onto the HOUSING as shown below:
Nut (N1)
ANCHOR BOLT(not Included )
SAFETY BRACKET
Nut (N2,N3)
SAFETY WIRE(not Included )
not Included
CEILING
HOUSING
I
`
ANCHOR BOLTS must be able to sustain the weight of at least 30 kg.
`
If you proceed without following the instructions in the manual, that is if you work with the
camera body already attached from the beginning, the safety wire could exceed its limit and
be broken when the housing is accidentally dropped, which could result in an accident.
3 After checking the hole size to use, remove the cap and the hex nut.
3 To connect to the camera, insert external connection cables through the CABLE HOLE
on the housing to the inside of the HOUSING as shown in the figure.
CEILING
5 Push the HOUSING inside the CEILING through the CEILING hole, and tighten the
SCREWs (x2) clockwise to fix the HOUSING on the CEILING.
(Adjust the height of the bracket to secure the housing to the ceiling.)
HEX NUT
BRACKET
CABLE HOLE CAP
I
`
Using a power tool for installation could cause product damage.
If you are going to use a power tool, the torque must be 30 Nm or less.
`
Ensure that the HOUSING is firmly secured to the CEILING BOARD.
5 Attach the camera module to the HOUSING.
• Applicable model
- XND-6083RV / XND-8083RV / XND-8093RV / XND-9083RV
5 Assemble the dome cover.
CEILING
TR20
4x
TR20
PT01-005800A
Advertisement
