Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Provision ISR OC-RS-16
- Page 1 Ossia VMS-5000 OC-RS-16(3U) Ossia VMS Recording Server...
-
Page 2: Table Of Contents
1.3 System Components ..............................1 1.3.1 System ................................1 1.3.2 System Role ..............................2 Hardware installation: ..............................2 2.1 OC-RS-16 (3U) HW Installation: ..........................2 2.2 OC-RS-16 (3U) Disk Installation: ..........................3 Management Web-Client .............................. 3 3.1.1 Network Config .............................. 3 3.1.2 Server Port Config ............................ -
Page 3: Introduction
Ossia VMS Enterprise User Manual Introduction 1.1 Summary OC-TS(1U) Media Transfer server is a part of the Ossia VMS system. It cannot work independently and must be connected to any Ossia VMS managemenr server in order to be active 1.2 Software Architecture Application Layer Mobile Phone The Third... -
Page 4: System Role
NVR local storage. The Ossia VMS allows you to choose the search/playback origin (weather from the NVR or from the Storage server). The OC-RS-16(3U) can also perform as a transfer server. The roles of the Media Transfer server are crucial. Without it, the system will not work properly and will not be able to stream video. Other roles include: Streaming video to the Ossia VMS clients (PC / Web / Mobile App). -
Page 5: Oc-Rs-16 (3U) Disk Installation
2.2 OC-RS-16 (3U) Disk Installation: The OC-RS-16(3U) supports up to 16 HDDs. It supports “hot swap” features, so it is possible to add, remove, or replace HDDs while the server is on. Still, for the initial installation, we advice to install the HDDs while the server is switched off. Note that not all the HDDs are required for the server to work properly. -
Page 6: Server Port Config
Ossia VMS Enterprise User Manual 3.1.2 Server Port Config From here you can configure the ports of the storage and media transfer server and the “Auto report” service. If you want to connect to the server via WAN, you will have to forward these ports to the server IP on your router. If some services are not needed, it is advisable to disable it. -
Page 7: Disk Management
Disk Management 4.1 General: The OC-RS-16(3U) support RAID0,1,5,6. Configuring the RAID can be done via the management web interface only. Browse to “Disk Config” to see the following interface: Here you will see all the available disks and their status (Based on the color indicators). If no RAID has been configured, the disks will work normally based on FIFO (First In First Out). -
Page 8: Deleting Raid
Ossia VMS Enterprise User Manual 4.2.1 Deleting RAID: Click on the RAID you wish to delete. It will be colored in red. Click on the “Delete” button and confirm. Please note: Deleting a RAID cannot be undone. All the data on the HDDs will be formatted. Adding a Server to the Management Server 5.1 Storage Server: The storage server is in charge recording video from video devices (NVR/DVR/IPC) and stream it through the media servers in case a... -
Page 9: Appendix I: Raid Types
Ossia VMS Enterprise User Manual Appendix I: RAID Types RAID0: Splits data evenly across two or more disks, without parity information, redundancy, or fault tolerance. • Minimum Disks: 2 • Data Striping • No storage “loss” • No Redundancy. RAID1: Mirrors data between 2 disks, creating 50% fault tolerance. •...
Need help?
Do you have a question about the OC-RS-16 and is the answer not in the manual?
Questions and answers