ATG M1 User Manual And Installation Instructiions

ATG-M1
ATG-M2
ATG-M2

LIMITED WARRANTY

ATG warrants any products purchased in the U.S.A. from an authorized ATG
dealer. All products are warranted to be free from defects in material and workmanship under
normal use and service for a period of (1) year when the unit installed by an authorized
ATG dealer. Non-authorized dealer installed products carry a (1)year parts and labor
limited warranty. This warranty applies to the original purchase only.
ATG will either repair or replace (as its option) any unit that has been found to be
defective and under warranty provided the defect occurs within:
One (1) year if purchased through an authorized ATG dealer. This limited warranty
does not extend to units that have been subjected to misuse, abuse, neglect, or accident.
Products that in ATG's judgment shows evidence of having been altered, modified,
or serviced without ATG 's authorization, will be ineligible under this warranty.
To obtain warranty service please contact your retailer or see our website www.atg-audio.com
for more details.
All warranty claims must be handled directly through the
authorized ATG dealer they were originally purchased from
ATG M1
Output Power @ 14.4 VDC, 2Ω 1 x 500W
Output Power @ 14.4 VDC, 4Ω 1 x 250W
Power Supply Input Voltage 12.0VDC to 14.8VDC
THD (1KHz @ 4Ω) 0.04%
Bandwidth (-3 dB) 18Hz - 22KHz
Damping Factor (1KHz @ 4Ω) 100
S/N ratio (as weighted @ 1 Volt) 99db
Input Sensitivity .0.2MV - 9V
Minimum Load Impedance 2Ω
Low-Pass filter range 50Hz ~ 150Hz
Sub-Sonic Filter Range 15Hz ~ 50Hz
Bass Boost 45 Hz @ 0 ~ 12dB
ATG M2
Output Power @ 14.4 VDC, 2Ω 2 x 250W
Output Power @ 14.4 VDC, 4Ω 2 x 125W
Output Power @ 14.4 VDC, 4Ω Bridge 1 x 500W
Power Supply Input Voltage 12VDC to 14.8VDC
THD (1kHz @ 4Ω) 0.04%
Bandwidth (-3dB) 18Hz- 22KHz
Damping Factor (1k Hz @ 4Ω) 100
S/N ratio (as weighted @ 1 Volt) 99dB
Input Sensitivity 0.2MV - 6V
Minimum Load Impedance 2Ω
High-Pass Crossover filter range 15Hz - 300Hz
Low-Pass Crossover filter range 50Hz - 300Hz
ATG Audio-to-Go
616-878-3500 / support@atg-audio.com
Made in China
WARNING: This product can expose you to
chemicals including lead, which is known to the
State of California to cause cancer. For more
information, go to www.P65Warnings.ca.gov
Due to continuous improvement of the product the Specifications are subject to change without notice.
M1
MONOBLOCK CLASS D AMPLIFIER
ATG M1 / ATG M2
User Manual

Installation Instructions

500 WATTS