VSCOM NetCom 111 POE Quick Installation Manual page 2

1. P L
ACKING IST
√ VS NetCom Server
√ Power supply adapter, AC to DC,
or power supply cord
√ CD-ROM with driver and configuration
software
√ Quick Installation Guide
Check if all parts are available. And also
carefully check if the adapter has the correct
voltage (110/220V AC) and connector for your
wall outlets.
2. H
ARDWARE
2.1. P S
OWER UPPLY
Connect the cable from the adapter to the
power jack at the rear side of NetCom. Place the
adapter into the wall outlet.
The red Power LED on NetCom will light.
2.2. E
THERNET
Connect the RJ45 on the rear side of NetCom to
your Switch or Hub. The yellow Link LED on
NetCom will light. When data traffic occurs on
the network, this LED will blink.
If you have a 100Mbit network the green Speed
LED on NetCom will light. If you have a
10Mbit network, the Speed LED remains dark.
2.3. S P
ERIAL ORT
The serial port of NetCom allows for different
operation modes, these are defined by DIP
switches. The factory setting is RS232 (like
COM1). Make sure this is still the situation with
your NetCom. To change this operation mode,
please consult the table printed on the NetCom
Server (top side), or the User Manual on the
CD-ROM.
3. N C
ETWORK
There are two basic configuration modes:
DHCP and Non-DHCP. Before you start,
contact your Network Administrator. He must
be informed about the new device in the
network, and he has to choose parameters.
You need them for driver installation.
C
ONFIGURATION
ONFIGURATION
4. D I
RIVER NSTALLATION
The driver setup is supervised by the Installation
Wizard. The Wizard will detect the NetCom
devices in your network. Later Windows will
find the serial ports via Plug & Play.
Insert the CD-ROM into your
drive. It will start automatic,
presenting
You have the choice to start the
installation direct from CD. If the
Installation
CD does not start, or you do not
Wizard
want it to, double-click the Icon of the Wizard.
You'll find it in the folder named as your
Windows system.
After copying some files the Wizard scans your
LAN for NetCom devices. Double-click each
devices icon to check the network parameters.
4.1. DHCP C
ONFIGURATION
The search for NetCom usually takes about 30
seconds. For the Quick Installation it is most
convenient to use the DHCP option. This option
is recommended.
Info Panel of NetCom Server (Network Configuration)
4.2. N -DHCP C
ON
If the NetCom is configured for DHCP, and
there is no server in the network, NetCom needs
up to 2 minutes to start. This is normal, and not
an error. You must uncheck "Use DHCP". Then
enter values "IP address" to "Name server".
W
IZARD
some information.
ONFIGURATION