Page 1
Panel is Nenko Interactive compatible and therefore also responds to controllers such as microphone, 6-button switch, cube and the Nenko Sense System. Comes with wall bracket with instructions. Including fixation system for the panel. The fixation screws for the wall are not included.
Page 2
7. Commissioning The panel is immediately ready for use: Simply plug the panel into the wall outlet and turn on the power. To turn on the panel, press the power button: The LCD screen lights up and displays a locking symbol. The panel starts in the last used mode. To unlock the panel, press and hold the up and down arrow keys for 3 seconds: The menu is now accessible.
Page 3
Volume Select the volume from the menu and press OK to change the volume: The volume can then be changed using the up and down arrow keys. Select the desired volume level, and then press OK again to save this setting. Brightness To change the brightness, select brightness from the menu, and then press OK: The brightness can then be changed using the up and down arrow keys.
Wireless connectivity can be customized with this setting. Connectivity can be turned on or off: When connectivity is enabled, the panel responds to other interactive products in the room, such as a Nenko Interactive – Cube. Turn connectivity on or off using the up and down arrow buttons. Select the desired setting, and then press OK again to save it.
Page 5
There are 5 pairing channels. Channel 0 is the default factory setting. When the panel is set to Channel 0, all compatible interactive switches in the room will operate the panel, e.g. wireless controller, Nenko Interactive – Cube etc. Select the desired pairing channel using the up and down arrow buttons. Select the desired setting, and then press OK again to save it.
8. Maintenance These panels are designed for low maintenance. Clean the outside as desired with a soft, damp cloth. 9. Technical information INPUT: 100-240V 50/60Hz, 1.5A OUTPUT: 12V 5A Power approvals: www.nenko.com. For more information, please visit our website...