Summary of Contents for Sapa Redd Team Dura-Grip General Code
- Page 1 Dura Grip Dura Grip General Code General Code System Assembly System Assembly General Compliance Dura-Grip Modular Building Access...
-
Page 2: Platform Components
General Code General Code Platform Components Platform Components Leg Pads Legs Hardware Platform Cone Platform... - Page 3 General Code General Code Stair Components Stair Components Stair Riser Riser Plate Hand rails Guardrail...
- Page 4 General Code General Code Stair Assembly Stair Assembly 1. Insert legs into platform cones, with leg pads facing inwards 2. Using the 2.5” Hex Head Cap Screws, finger tighten at following heights, from platform surface to leg pad: 28”- 3 Step System 35”...
- Page 5 General Code General Code Stair Assembly Stair Assembly 3. Flip platform upright and bring to threshold...
- Page 6 General Code General Code Stair Assembly Stair Assembly 4. Adjust the height of the legs so that the system is flush with threshold - use dirt or plates under leg pads to level the platform if needed...
- Page 7 General Code General Code Stair Assembly Stair Assembly 5. Attach stair riser with 4.5” Hex Head Screws for sides (shown below) and #10-3/4” Hex Head Tek Screws for the Riser Plate...
- Page 8 General Code General Code Stair Assembly Stair Assembly 5. Lag platform to building with (3) ¼” x 3” Lag Screws, through holes provided on landing...
- Page 9 General Code General Code Stair Assembly Stair Assembly 6. Insert both guardrails so that they rest on the ¼” x 4 ½” bolts previously inserted...
- Page 10 General Code General Code Stair Assembly Stair Assembly 7. Connect Landing Rail Clip to landing rail using (2) #14 x 3/4” Hex Head Tek screws - then connect clip to building using (2) ¼” x 2” Lag Screws...
- Page 11 General Code General Code Stair Assembly Stair Assembly 8. Connect guardrails together with Corner Clip angle using (2) #14 x ¾” Hex Head Tek Screws...
- Page 12 General Code General Code Stair Assembly Stair Assembly 9. Install the stair rail by inserting the bottom of rail into platform cone then top - make sure that the rails sit on the ¼” x 4 ½” bolts...
- Page 13 General Code General Code Stair Assembly Stair Assembly 10. Connect Landing Rail to Stair Rail using stair corner clip angle and (2) #14 x 3/4” hex head Tek screws...
- Page 14 General Code General Code Stair Assembly Stair Assembly 11. Connect Stair Rail to Landing Rail Clip using (2) #14 x 3/4” Hex Head Tek screws - then connect clip to building using (2) ¼” x 2” Lag Screws...
- Page 15 General Code General Code Stair Assembly Stair Assembly 12 Make sure ground is level at bottom of first riser - add or remove dirt as necessary - must maintain a 7” riser height to remain within code compliance...
- Page 16 General Code General Code Stair Assembly Complete Stair Assembly Complete...
Need help?
Do you have a question about the Redd Team Dura-Grip General Code and is the answer not in the manual?
Questions and answers