Advertisement
Repair
Have your power tool serviced by a qualified repair person using only original identical replace-
ment parts. This will ensure that the safety of the power tool is maintained. Do not use any damaged
tool. Do not repair a tool yourself if you are not qualified to do so.
Safety instructions for staplers
•
Secure the workpiece (a workpiece clamped with clamping devices or in a vice is held more
securely than by hand) to avoid injuries.
•
Never push the stapler head manually (there is a danger of injury when the trigger is activated
unintentionally at the same time).
•
Never use the tool for fastening electrical wiring (contact with electrical wires can lead to
fire and electric shock).
•
Avoid damage that can be caused by screws, nails, and other elements in your workpiece;
remove them before you start working.
•
Always check that the supply voltage is the same as the voltage indicated on the type label of
the stapler (staplers with a rating of 230 V or 240 V can also be connected to a 220 V supply).
•
In case of electrical or mechanical malfunction, immediately switch off the tool or unplug the
charger from the power source.
•
Flawless functioning of the tool can only be ensured when original equipment is used.
•
This tool should not be used by people under the age of 16. Underage persons and persons
with reduced mental or physical abilities should only use this kind of tools while being supervised
by a person responsible for their safety.
•
Do not expose the tool to rain, wet conditions, or high air humidity.
Use
Loading staples/nails (see fig. 6)
1.
Turn the tool upside down.
2. Press the lever A while pulling the slider B backwards.
3. Insert the staple/nail strip into the magazine C with the staple points facing up (max. capacity
100 staples).
4. Push the slider B against the stapler head D until it locks.
5. When inserting a nail strip (not supplied with the tool), tilt the tool, so that the nail strip rests
against the magazine side which corresponds with the nail symbol in the stapler head D (see
fig. 7).
Operating the tool (see fig. 8)
1.
Timely press the stapler head D against the workpiece until it is pushed in a few millimetres.
2. Press the trigger E, then release it again.
3. The switch F is locked, as long as you do not press the stapler head D against the workpiece,
preventing accidental operation.
4. At 20
shots
⁄
and after 30 min, the stapler should be allowed to cool down, as it is only rated for
min
short-time use.
Remove all staples/nails from the magazine after each use!
Impact control (see fig. 9)
1.
The required impact level can be selected in steps with the wheel F.
2. The indicating arrow shows the selected impact level.
3. Use "–" for thin and light materials such as foils and fabrics.
4. Use "+" for thick and tough materials such as hard woods and similar materials.
5. Before starting, find the optimal impact level by testing out on spare material.
https://www.XPOtool.com
The Tool Experts
Item 61859
Page 5
05 2022-1
Advertisement
