tayogo T03 Instruction Manual

WIFI Pair

● Power both GoPro and Controller
● Go to GoPro Setting, Connect—Connect New Device—Smart
Remote to pair. Once connected, GoPro will show connected
and controller LED keep full blue.
Note:：
1. Controller can connect with only 1 GoPro
2. If pairing failed, please power on again both GoPro and controller
to try again.
3. Please reset connections of GoPro to connect the new GoPro.
Operatoin:
1.You can use the controller to control Gopro once connected.
2.Controller can power on/off GoPro
3.Shutter and Mode of the controller works same as GoPro buttons.
Other setting by touch screen need to be done before diving.
4.You can adjust the GoPro Adapter, or the main player adapter
to the right position or direction to shoot as you want.
5. Scroll left to pull up or down the stick, scroll right to lock.
Plug Hole
LED Indicator
Charging：
● Plugging the charging cable to the main player hole with USB
Port or 5V 1A USB adapter.
LED Indicator
Cable Plug Hole
（Please screw the cable tightly before diving)
LED Indicator
Controller LED: Full blue after connection, flash fast for pairing
Power LED: Full red during charging and no led after fully charging
( on the main player)

Problem and solution

Pairing fail: remove Gopro connection and try again
Power on fail: Check if the main player is charged; check if the
cable is well connected and try again.
Button not work: please check if the cable is well connected with
main player.
Matainance
Do not pull the stick back/forward strongly as the connection
cable is hidden inside. The stick will lose function if cable is broken.
After usage, please pull back the stick to the short length to keep
the inside cable good condition.
Please disconnect the main player and the controller if no use.
Please charge the main player first after long time no use.
Please screw the connection cable tightly into the main player
before diving, otherwise main player will be broken under water.