Table of Contents
Advertisement
Fault
Appliance door opens too
wide at the end of the pro-
gramme.
Error code / Fault display / Signal
Fault
E:21-30 will light up altern-
ately.
E:20-60 lights up alternately. Appliance has detected cal-
E:30-00 will light up altern-
ately.
E:31-00 will light up altern-
ately.
E:34-00 will light up altern-
ately.
E:32-00 will light up altern-
ately or indicator for water
supply lights up.
1
Depending on the appliance specifications
Cause
Door is not correctly adjus-
ted.
Wrong screws used to ad-
just the door gap.
Cause
Intake opening of Zeolith
container is covered by
items of tableware.
cified heating element.
Water protection system is
activated.
Water protection system is
activated.
Water is continuously run-
ning into the appliance.
Supply hose is kinked.
Water tap is turned off.
Water tap is jammed or
furred up.
Troubleshooting en
Troubleshooting
Adjust the appliance door as de-
▶
scribed in the installation instruc-
tions.
The door gap must be at least
70 mm - 100 mm.
Use size 4X30 bolts to adjust the
▶
door gap.
The bolts are included in the scope
of supply.
If you use bolts that are too long,
this can deactivate the function of
automatic door opening.
Troubleshooting
Re-arrange the tableware in the ap-
▶
pliance so the "Intake opening of
the Zeolith container " → Page 15
is no longer obstructed.
Descale the appliance.
1.
Operate the appliance with the wa-
2.
ter softening system.
Turn off the water tap.
1.
Call "Customer Service"
2.
→ Page 58.
Turn off the water tap.
1.
Call "Customer Service"
2.
→ Page 58.
Turn off the water tap.
1.
Call "Customer Service"
2.
→ Page 58.
Install the supply hose without
▶
kinks.
Turn on the water tap.
▶
Turn on the water tap.
▶
The flow rate must be at least 10 l/
min when the water supply is open.
1
45
Advertisement
Table of Contents
