Siemens WK14D321GC Instruction Manual And Installation Instructions page 15

Fluff Clean
Special programmes
The drum must be empty.
This programme is designed to clean the drying cycle of any fluff
deposits. The washer-dryer uses the flashing symbol (Fluff removal
l
cycle) in the display panel to show that this programme must be run. The
electronic cycle counter is then automatically reset. The (Fluff removal
7
cycle) symbol goes out after the programme starts.
To run the Fluff Clean programme, proceed as follows:
 Make sure that the drum is completely empty and close the door.
 Set the programme selector to Fluff Clean.
 Press the Start/Pause button.
You can also run the Fluff Clean programme at any time without
prompting from the appliance.
Rinse + Spin
:
An additional rinse cycle with a final spin. If the laundry is to be removed
dripping wet, set the spin speed to $ (Rinse stop) before starting the
programme → page 15.
Empty + Spin
:
Drain the rinsing water following a programme with $ (Rinse stop)
→ page 15.
 Turn the programme selector to Empty + Spin.
 Set the spin speed to $ (Rinse stop).
 Press the Start/Pause button.
or
Drain and spin at the desired spin speed:
 Turn the programme selector to Empty + Spin.
 Press the Spin rpm button repeatedly until the desired spin speed is
set.
 Press the Start/Pause button.
14