Chapter 4. Secure Your Computer And Information; Use Passwords; Password Types; Set Administrator Password - Lenovo 81ND00HDMB User Manual

Table of Contents

Advertisement

Chapter 4. Secure your computer and information

Use passwords

This section introduces types of passwords in UEFI (Unified Extensible Firmware Interface) or BIOS (Basic
Input/Output System) and how to set, change, and remove a password.

Password types

You can set various passwords in the UEFI/BIOS setup utility.
Password type
Administrator password
User password
Master hard disk password
User hard disk password
Notes:
• All passwords set in the setup utility consist of alphanumeric characters only.
• If you start the setup utility using the user password, you can only change a few settings.

Set administrator password

You set the administrator password to prevent unauthorized access to the UEFI/BIOS setup utility.
Attention: If you forget the administrator password, a Lenovo authorized service personnel cannot reset
your password. You must take your computer to a Lenovo authorized service personnel or a marketing
representative to have the system board replaced. Proof of purchase is required and a fee will be charged for
parts and service.
Step 1.
Start the UEFI/BIOS setup utility.
Step 2.
Select Security ➙ Set Administrator Password and press Enter.
Step 3.
Enter a password string that contains only letters and numbers. Then press Enter.
Step 4.
Enter the password again and press Enter.
Step 5.
Select Exit ➙ Exit Saving Changes.
Next time you start the computer, you must enter the administrator password to start the setup utility. If
Power on Password is enabled, you must enter the administrator password or the user password to start
the computer.

Change or remove administrator password

Only the administrator can change or remove the administrator password.
© Copyright Lenovo 2018
Pre-requisite
No
The administrator password must be
set.
No
The master hard disk password must
be set.
When set
You must enter it to start the setup
utility.
You can use the user password to
start the setup utility.
You must enter it to start the
operating system.
You can use the user hard disk
password to start the operating
system.
21

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ideapad s540-14iwlO ideapad s540-14iwl touchIdeapad s540 series

Table of Contents