Becker C-14 Instructions

C-14 | Pacific Adjustable Collar - English
Instructions

SIZING

1. Measure from the apex of the mandible to the sternal
notch in a straight line.
2. Select correct size based on table
Small/Medium
Medium/Large

APPLICATION OF COLLAR

1. Apply collar to patient's neck, making sure mandible is centered securely in the
recess and that the lower portion is flush with the sternum.
2. Height of collar can be adjusted by following these steps:
a. Turn screws counterclockwise one full turn to loosen.
b. Move plastic shell vertically until desired height is reached.
c. Re-tighten screws.
CAUTION – Do not over torque screws.
3. Secure with strap.
4. Make any final adjustments as necessary. The space between the anterior and
posterior sections should be even on both sides.
5. Cut off excess strap as needed.

PATIENT INSTRUCTIONS

The neck collar should only be removed for hygienic needs (e.g. bath), unless
otherwise stated.
NOTE! Always follow the instructions given by your practitioner. Should you
notice extreme discomfort, skin breakdown, increased pain, numbness or tingling,
please consult your healthcare practitioner immediately.

REMOVAL OF COLLAR

1. To remove the collar, release the strap on one side of the
collar only (Fig.1). Remove the collar and set it aside.
2. Keeping your neck still and straight, gently wash and
thoroughly dry your face and neck.
3. If necessary, replace liners with clean, dry liners. (See
instructions on back for proper cleaning procedures)

PUTTING COLLAR BACK ON

4. To re-apply the collar, place the anterior (front) portion on your neck.
Important note: Do not loosen knobs or attempt to change the height of the
collar. All adjustments must be made by your practitioner to ensure
5. While securely holding the front portion to your body, swing the
to the back of your neck and feed the strap through the loop. Pull the strap
forward until the collar is snug and secure the strap in place (Fig.2).

WASHING INSTRUCTIONS

The neckline padding is in three different parts:
1. The upper front part
2. The lower front part
3. The rear part
WASH
1. Remove the three parts from the neck collar
2. The parts must be washed in lukewarm mild soapy water Rinse the parts in
and gently squeeze out as much water as possible. Allow the parts to air dry.
4. Plastic parts can be cleaned with lukewarm soapy water. Then wipe.
5. Put the padding back in the neck collar when both parts have dried. It's just
one side of the padding which can attach to the velcro straps on the inside of the
neck collar. Check that the padding is seated correctly so that it extends beyond
the edge of the neck collar.
Note: It is important to ensure the liners are kept clean and dry. The liners should be changed and
cleaned as needed. Do not use a washing machine, dryer, bleach, or harsh chemicals when cleaning liners
or straps.

GENERAL USE AND CARE PRECAUTIONS

The use of orthoses should be supervised by a qualified and certified orthotist, or
orthotic fitter. Failure to correctly fit the orthosis and educate the patient and/or
patient's care giver regarding proper adjustment, positioning and monitoring
procedures could result in discomfort, or skin irritation due to the highly
supportive and restrictive nature of these medical devices. Any pads fit to device
should always remain in place except when briefly removed for cleaning.
of the pads of an orthotic device can result in skin irritation or breakdown. Do
not wear the orthosis without padding.
5.6 – 9.4cm
8.1 – 13.1cm
proper fitting
back portion

Appropriate positioning of the patients wearing an orthosis can help to
reduce focal pressure and the risk of irritation. Consult your orthotist on
proper positioning and use of the orthosis.

The patient's skin should be regularly and routinely inspected for signs of
irritation. Signs of excessive focal pressure will present as skin redness
lasting longer than 30 minutes after repositioning.

If signs of irritation, or excessive focal pressure should occur, contact a
qualified orthotist, or orthotic fitter for evaluation.
.
Removal