Advertisement
ASSEMBLY / OPERATING INSTRUCTIONS
To install on the Stroller Continued...
1b.
Align the teeth of the two straps and feed the
1
spindle end through the Attachment Bracket until
the strap spindle comes through the back of the
Attachment Bracket.
1c.
Secure the Attachment Bracket by screwing the
Attachment Strap Thumbscrew onto the strap
spindle until fully tightened and secure.
PLEASE NOTE!
If the Attachment Bracket is still not tight on the Stroller rear leg
after assembly,please undo the Strap Thumbscrew and remove
the Attachment Strap.
Take scissors and shorten the straps using the below formula.
Repeat for the second attachment strap. Ensure all straps are cut
to the same length.
Re-fit straps and attachment bracket, ensuring the bracket is tight
on the Rear Stroller Leg and does not move.
Please take care when performing this step to ensure the straps
are not cut too short and are not able to be assembled correctly.
Formula for shortening straps:
Measure the circumference of the Stroller Rear Leg. Subtract
this number by 12, then divide by 2. (Example: If your stroller leg
circumference is 9cm, 12-9=3. Divided by 2=1.5. You will need to
cut off 1.5cm from both sides of the attachment strap.
Repeat steps 1a-1c for the remaining Attachment
1d.
Strap and Attachment Bracket.
1e.
Flip Stroller Board and align Extension Arms with the
Attachment Brackets on the rear of the Stroller.
1f.
Ensure the mounting posts of the Extension Arms
align with the mounting slot on the assembled
Attachment Brackets.
If necessary, adjust the width of the Extension Arms
in or out of the Stroller Board to ensure the correct
alignment.
1g.
Attach the Extension Arms to the Attachment
Brackets by pushing the mountings posts down and
into the mounting slots until they lock in and are
secure.
7
Advertisement
