Cleaning The Appliance - Siemens KA D Series Installation Instructions And Instructions For Use

en

Cleaning the appliance

m
Warning
Never clean the appliance with a steam cleaner!
m
Caution
Do not use abrasive, chloride or acidic cleaning agents
or solvents.
m
Caution
Do not use scouring or abrasive sponges. The metallic
surfaces could corrode.
m
Caution
Never clean shelves and containers in the dishwasher.
The parts may become deformed!
Proceed as follows:
1. Pull out the mains plug or switch off the fuse.
2. Take out the frozen food and store in a cool location.
3. Wait until the layer of frost has thawed.
4. Clean the appliance with a soft cloth, lukewarm water
and a little pH-neutral washing-up liquid. The rinsing
water must not run into the light.
5. Wipe the door seal with clear water only and then
wipe dry thoroughly.
6. After cleaning reconnect the appliance.
7. Put the frozen food back into the appliance.
Interior fittings
To clean the equipment, all variable parts of
the appliance can be taken out (see chapter Variable
interior design).
Note
To take out and clean the containers, open the doors
fully beyond 90°.
Removing the container
Pull out container all the way, lift to detach it from
the holder and take out.
To insert the container, place on the telescopic rails
and push into the appliance. Attach the container by
pressing it down.
40
Cleaning the water collection tray
Spilled water collects in the water collecting tray.
To empty and clean, remove the filter. Wipe out water
collecting tray with a sponge or absorbent cloth.
Cleaning the ice cube container
If ice cubes have not been dispensed for a prolonged
period, they will shrink, have a stale taste and stick
together.
Pull out the container, empty and clean with lukewarm
water.
m
Caution
A full ice cube container is heavy!
After cleaning, dry the container and feed screw
thoroughly to prevent the new ice cubes from sticking.
Inserting the ice cube container
Push the ice cube container all the way back onto
the supports until it locks into position. Ice cube
production continues.
Note
If the container cannot be pushed all the way back,
twist the screw conveyor in the container or remove
frozen ice cubes from the area of the shelf.