Toro 30856 Setup Instructions page 2

Install Cutting Unit Lift Latch
1. Rotate latches and remove control panel cover (Fig. 2).
1
2
Figure 2
1. Operators control panel
2. Capscrews
3. L.H. latch bracket
2. Under front of control panel, locate ends of capscrews
securing control panel to frame (Fig. 2).
3. Insert left hand latch bracket up thru lift lever slot and
onto capscrew. Loosely secure with 1/4–20 flange nut
(Fig. 2).
4. Insert right hand latch bracket up thru lift lever slot and
onto capscrew. Loosely secure with 1/4–20 flange nut
(Fig. 2).
5. On top of control panel, insert each end tab of lift latch
into holes in latch brackets (Fig. 2). Tighten flange nuts.
4
5
3
4. R.H. latch bracket
5. Lift latch
Installing the Hood Latch
1. Unhook the hood latch from the hood latch bracket
(Fig. 3).
2. Slide the hood lock bracket onto the latch (Fig. 3).
3. Hook the latch onto the hood latch bracket (Fig. 3).
4. Insert a bolt (1/4 x 1-1/2 in.) through the hood lock
bracket and secure it with a flat washer and locknut
(Fig. 3).
2
3
Figure 3
1. Hood latch
2. Hood latch bracket
2
1
3. Hood lock bracket