Advertisement
Available languages
Available languages
Montage-/ Betriebsanleitung
Mounting-/Operation Instruction
EN
Congratulations on your purchase of this nobilé-product!
You have decided on a high-quality product which is manufactured with the utmost care and subject to several quality controls. Safe use of the product is only guaranteed
if each instruction is followed accordingly. In case of damage caused by non-observance of these instructions the warranty expires. The installation and electrical
connection must be done by an authorized expert (e.g. electrician) in compliance with existing standards and local code. Prior to any installation or maintenance work,
mains must be disconnected. Before putting in operation, make sure any component of the entire installation does not bear a risk of life. According to common practice,
please perform a standard function test, before installing. The test also includes a light colour test. To make maintenance work possible, the lighting system should be
accessible after installation (auditable). LEDs are electronic components. Their lifetime is influenced by the ambient temperature, therefore proper heat dissipation must
be assured as well as constant convection. When mounting the LED tapes, ESD-protected gloves shall be worn and, in addition, ensure personnel grounding
(electrostatic discharge). The product shall not be subjected to vapor with salt, chlorine, ozone or similar contents and exposure to direct sunlight must be avoided.
This product contains a light source of energy efficiency class <F> or <G>.
IP20
IP67
Connection Diagram:
Safety Warning:
Only install with constant voltage LED power supplies safety transformer, preferably LED power supplies that comply with Class II standard.
The Flexible LED and all its components must not be mechanically stressed. Observe the allowable bending radius of 30mm and do not install in area
with heavy vibrations.
Observe correct polarity! Incorrect polarity will lead to no light emission and may cause damage of the Flexible LED.
Observe maximum current capacity of the Flexible LED. Do not overload the Flexible LED.
When mounting on metallic or conductive surfaces, ensure to electrically isolate the Flexible LED especially at soldering points between module and the
mounting surface.
Observe the maximum operating temperature of the Flexible LED, failing to do so will lead to shorter product lifetime. It is recommended to mount the
Flexible LED on an Aluminum Profile for better heat dissipation.
Mounting instruction:
Place all the necessary materials ready: 1x scissors, 1X ESD-ground strap, 1x ESD- grounding gloves and the Flexible LED.
When sticking on do not apply pressure on the LEDs, only on the gaps between the LEDs, and do not bend the Flexible LED.
Sufficient cooling of the flexible LED must be ensured. We recommend mounting on materials with good thermal conductivity, such as the aluminum profile.
Exposure of the product to direct sunlight is prohibited.
The surface must be clean, dry and free of oil and grease so that the adhesive tape can sticks properly. Find out the required length, cut to size accordingly
and remove the protective film. Put the Flexible LED completely and flat on the surface, as otherwise the sufficient cooling of the LEDs is not guaranteed
and a reducing of the light output resp. failure of the LEDs can occur.
After cutting the required length the connecting cable must be soldered on (max. 270°C/ 3 seconds) or the connecting cable plugged on. Splitting only the
marked cut surfaces possible.
1
Flexible LED SMD 5050 14,4W/m 24V (IP20 / IP67)
3000K
4000K
Technische und gestalterische Änderungen im Zuge stetiger Produktentwicklungen vorbehalten.
Technical and design changes due to product developments are subject to change without prior notice.
nobilé AG – Wächtersbacher Str. 78 - 60386 Frankfurt/M. Germany - www.nobile.de
6500K
2
rev. 0.1 – 31.05.2022
Seite 2 von 2
3
Advertisement
