Govee DreamView G1 Manual

Caution
This product is suitable for 24-29 inch monitors.
Keep the back panel of the monitor dry and clean before installing.
The included strip light is only for monitors with a smooth back panel.
Monitors with the following three back panel types are not supported.
01
Before Installation
Step 1
Insert the strip light, light bars, and the DC power adapter cord into
the corresponding ports of the camera as shown in the image.
Plug the kit into power to check that all parts are functioning properly,
then unplug the kit from power and disconnect its parts from the
camera.
Light Bars x2
Step 2
Neon Strip Light
Wipe the back panel of the monitor to make sure its surface is dry and
Gaming Camera clean.
Power Adapter
Headphone Linking Cable
Foam Stickers
Straight Mounting Clips x5
Corner Mounting Clips x4
Cable Clip x2
Positioning Card x2
02
Installation Steps
Step 1
Select a positioning card based on the size of the monitor.
Unfold the card, and align it with the back panel to identity the
correct attachment positions for the mounting clips.
Slowly remove the card's adhesive film and stick it on the back
panel.
Step 2
Install the mounting clips as shown in the positioning card. Press each
Power Button
clip for 10 seconds when installing to ensure they are fully attached.
Audio Port
Neon Strip Light Port
Light Bar Port
Power Port
03 04