Unit Overview; Operating Modes; Fan Operation; Recirculating Mode - Thermador Masterpiece VCI3B30ZS Use And Care Manual

Custom insert hoods
Hide thumbs Also See for Masterpiece VCI3B30ZS:
Table of Contents

Advertisement

Available languages

Available languages

U N I T O V E R V I E W
Refer to the illustration at right to identify the parts of your appliance:
A: Decorative panel (the fi lter is located behind)
B: LED modules
C: Touch control panel.
O P E R A T I N G M O D E S
You can use this appliance in the air extraction or the recirculation mode.
NOTE: All openings in ceiling and wall where the hood will be installed
must be sealed.

Fan operation

The air that is drawn in is cleaned by
the grease fi lters and exhausted outdoors
by a ductwork.
NOTE: Ventilation may not exit through an already operational smoke
or exhaust chimney, nor a duct used for ventilating furnace
installation areas.
If the ventilation is intended to pass through a smoke or exhaust
chimney that is not in operation, the responsible area heating
inspector must give approval.
If the ventilation passes through an external wall, use a telescopic
wall sleeve.

Recirculating mode

The air that is drawn in is cleaned by the grease
fi lters and activated carbon fi lters and returned
back into the kitchen.
WARNING
Improper installation of gas appliances and ventilation hoods can create
a risk for carbon monoxide which can be harmful. To reduce the risk
of carbon monoxide poisoning, ensure the gas appliance is properly
installed according to the manufacturer's instructions, as well as ensuring
the hood is vented to the outside for proper exhausting of gases or
fumes.
Refer to local building codes for latest requirements and restrictions
when installing ventilation products in recirculation
Page 8
B
Recirculating mode fi lter
To bind odors in recirculating mode, a charcoal fi lter must be installed. The
required charcoal fi lter kits are available for purchase from specialist retailers,
from customer service or from the Online Shop. See table below to fi nd out
the fi lter kit part number corresponding to the unit model.
Installing recirculating mode fi lter
1. Open the decorative panel (A), then remove and set aside the fi lter
mode.
C
A
Unit Model
VCI3BZ30ZS
VCI6BZ30ZS
VCI3BZ36ZS
VCI6BZ36ZS
from the module and frame assembly by pulling down its tab (B).
B
A
B
Charcoal Filter Kit
CHFVCI30ZS
CHFVCI36ZS

Advertisement

Table of Contents
loading

Table of Contents