TABLE OF CONTENTS Catler recommends safety first Know Your FG 403 FOOD+ Assembling Your FG 403 FOOD+ Operating your FG 403 FOOD+ Care and Cleaning Troubleshooting TABLE OF CONTENTS...
Page 4
Congratulations on the purchase of your new FG 403 Food Grinder FOOD+. CONGRATULATIONS...
Page 5
CATLER RECOMMENDS SAFETY FIRST We understand the importance of safety and that’s why we put your safety first from the initial design concept to the production itself. Nevertheless, we ask you to be careful when using electrical equipment and to observe the following guidelines: •...
Page 6
• Use the appliance only with the accessories supplied with it. The use of other accessories is prohibited. • Use the appliance according to the instructions in this manual. Otherwise, there is a risk of personal injury. CATLER RECOMMENDS SAFETY FIRST...
Page 7
All repairs or adjustments must be performed at the nearest Catler authorised service centre. • Any maintenance other than routine cleaning must be entrusted to an authorised Catler service centre. CATLER RECOMMENDS SAFETY FIRST...
(with a nominal residual operating current of no more than 30mA) in the electric circuit in which your appliance is to be connected. For further expert advise, please contact your electrician. Instructions are also available at www.catler.eu. CATLER RECOMMENDS SAFETY FIRST...
KNOW YOUR FG 403 FOOD+ MOTOR UNIT 1. Safety lock 2. Control panel 3. Motor Unit 4. Ventilation openings 5. Base 6. Suction cups (located at the bottom, provide greater stability of the base) KNOW YOUR FG 403 FOOD+...
Page 10
CONTROL PANEL 1. button: used to switch the appliance on/off 2. Low speed button 3. High speed button 4. Reverse button KNOW YOUR FG 403 FOOD+...
Page 11
1. Front cover with pulp outlet 2. Fine strainer 3. Worm shaft for juicing 4. Grinding chamber 5. Juice outlet 6. Filling funnel 7. Juicing attachment hopper 8. Juicing attachment plunger 9. Pulp container 10. Juice jug 11. Pulp separator KNOW YOUR FG 403 FOOD+...
Page 12
5. Grinding chamber 6. Filling funnel 7. Food grinder hopper 8. Food grinder plunger 9. Attachments for sausage preparation 10. Cover for sausage preparation attachment 11. Attachment for kubbe preparation 12. Cover for kubbe preparation attachment KNOW YOUR FG 403 FOOD+...
ASSEMBLING YOUR FG 403 FOOD+ ASSEMBLING THE JUICING ATTACHMENT 2. Make sure that the lock is turned so that the arrow points to the open lock symbol. 1. Place the motor unit on a dry, level and 3. Insert the food grinder into the motor firm surface.
Page 15
4. Fit the hopper onto the filling funnel and insert the plunger into the funnel. 5. The appliance is now ready for use. 6. To disassemble, perform the procedure in reverse order. ASSEMBLING YOUR FG 403 FOOD+...
OPERATING YOUR FG 403 FOOD+ BEFORE FIRST USE WARNING! Before first use, remove all packaging TO PUSH and advertising labels / stickers from the appliance. Make sure you have removed all INGREDIENTS accessories from the package. THROUGH THE Wipe the motor unit with a soft cloth slightly dampened with warm water.
Page 17
By choosing the grinding disc you choose the fineness or coarseness of the mixture in the sausage. If you prefer a coarser sausage mixture, use the grinding disc with the largest holes and vice versa. OPERATING YOUR FG 403 FOOD+...
CARE AND CLEANING MOTOR UNIT Before cleaning the appliance, always switch it off and unplug the power cord from the Wipe the motor unit with a soft cloth slightly mains socket and allow it to cool down dampened with warm water. Wipe dry using sufficiently.
TROUBLESHOOTING This chapter describes the most common problems you may encounter while using this appliance. If your problem is either not stated here or persists, stop using the appliance, unplug the power cord and contact your authorized service centre. UNDER NO CONDITION SHOULD YOU REPAIR OR DISASSEMBLE THE APPLIANCE YOURSELVES.
Page 20
INSTRUCTIONS AND INFORMATION ON DISPOSING OF USED PACKAGING MATERIALS Dispose of used packaging material at a site designated for waste in your municipality. DISPOSING OF USED ELECTRICAL AND ELECTRONIC EQUIPMENT This symbol on products or original documents means that used electric or electronic products must not be added to ordinary municipal waste.
Need help?
Do you have a question about the FG 403 and is the answer not in the manual?
Questions and answers