Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for nabaidun PD30-WAE-F
- Page 1 USER’S MANUAL Product name：Dehumidifier Model: PD30-WAE-F...
-
Page 2: Safety Information
SAFETY INFORMATION 1. Please read the operating instructions carefully beforeusing your dehumidifier for the first time and keepthem in a safe place. 2. Never immerse the appliance in water or other liquids. 3. Never operate the appliance if a cable or connectorhas been damaged, after appliance malfunction or ifthe appliance was dropped or is otherwise damaged. - Page 3 fixturesand fittings to maximize airflow and dehumidificationefficiency 12. This appliance is not intended for use by persons(including children) with reduced physical, sensory ormental capabilities, or lack of experience andknowledge, unless they have been given supervisionor instruction concerning use of the appliance by aperson responsible for their safety.
- Page 4 OPERATING INSTRUCTION 1.Control panel 2.Air outlet 3.Top panel 4.Handle 5. Front panel 6.Air inlet /back panel 7.Continuously drainage hole 8.Tank handle 9. Water tank...
-
Page 5: Control Panel Description
CONTROL PANEL DESCRIPTION OPERATION INSTRUCTION Starting the unit Allow the unit to stand upright for 24hrs to let the compressor stabilizebefore first use or when transported. 1. Plug in the dehumidifier. 2. Turn on the unit by push power button. 3. -
Page 6: Fan Speed
1. POWER Press this key to set “POWER ON, POWER OFF”. The light is on when” POWER ON”, and glimmer when” POWER OFF”. 2. FAN SPEED Push this key to choose fan speed: This fan light on is high fan speed; This fan light on is low fan speed;... -
Page 7: Function Description
AUTO MODE LAUNDRY MODE It will be chosen by the relative light is on. 7.WIFICONNECTION 1) Turn on the unit, the WIFI light will be sparkled for 30s, and the equipment will receive the WIFI signal.After connection the WIFI light will be on. 2) Long time push WIFI button for 3s, WIFI will do re-connection. - Page 8 TANK FULL When the light is on, it means the tank is full then the unit will stop working. To empty the tank and press the power button, the unit will run again. DEFROST When this light is on, the unit is in defrosting. At this time, the compressor is stop running, but the fan is working.
-
Page 9: Usage Of Water Tank
not start after 10 minutes, please ask your local distributor service station to repair. When the dehumidifier is operating, it’s a normal situation that the working compressor may cause some heat and bring the ambient temperature up. When the product is defrosting, the related indicating light will illuminate. -
Page 10: Continuous Drainage
Fig 01 CONTINUOUS DRAINAGE 1. Before continuous draining water, please take out the water tank and plug a draining tube to draining hole(See Fig 02.) Then put the water tank back. 2. Draining tube should place lower than the draining hole to let water flow out. - Page 11 The unit is not allowed to be placed on surface which is soft ornot flat to avoid the unit cause noise, vibration, and water or electricity leakage when operating. Never insert any slim rod or hard stuff into the unit to avoid the damage of the unit.
- Page 12 Copper tube sensor damaged Ask professionalservice agent for help Model PD30-WAE-F Power Source 120V～60Hz Rated Power (104℉,35%RH) 490W SPEC Rated Current (104℉,35%RH) IFICA Rated Capacity (65℉,60%RH) 30 Pints/Day(16.5L/Day) TION Input Power (65℉,60%RH) 340W IEF(65℉,60%RH) 1.60 Liters/kWh Motor FLA 0.43A Motor Compressor RLA:3.3A LRA:19.4A...
- Page 13 Its total global warming potential (GWP) is 2088. This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent possible hazards to the environment or human health from uncontrolled waste disposal, please recycle it to prove the sustainable reuse of material resources.
- Page 14 FCC Warning This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any inte rference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.