Maytag MVWX600XW Use And Care Manual page 13

TROUBLESHOOTING
First try the solutions suggested here or visit our website at www.maytag.com/product_help -
If you experience
Washer not performing as expected cont.
Washer won't run
or fill, washer stops
working or wash light
remains on (indicating
that the washer
was unable to fill
appropriately) (cont.)
In Canada, www.maytag.ca, for assistance and to possibly avoid a service call.
Possible Causes
Check for proper electrical
supply.
Normal washer operation.
Washer may be tightly packed.
Not using HE detergent or using too
much HE detergent.
Plug power cord into a grounded 3 prong outlet.
Do not use an extension cord.
Ensure there is power to outlet.
Reset a tripped circuit breaker. Replace any blown fuses.
NOTE: If problems continue, contact an electrician.
Lid must be closed for washer to run.
Washer will pause during certain phases of cycle. Do not
interrupt cycle.
Washer may be stopped to reduce suds.
The washer senses the dry load with short spins that may take
2 to 3 minutes before water is added. You may hear the hum of the
spins. This is normal.
Remove several items, rearrange load evenly around the washplate.
Do not load garments directly over the center of the washplate.
Close lid and press START/Pause/Unlock.
Add only 1 or 2 additional garments after cycle is started.
Do not add more water to the washer.
Only use HE detergent. Suds from regular detergents can slow or
stop the washer. Always measure detergent and follow detergent
directions based on your load requirements.
To remove suds, cancel cycle. Select Rinse & Spin. Press START/
Pause/Unlock. Do not add more detergent.
Solution
13