Advertisement
Mounting and Hardware
MOUNTING
1. Select the desired mounting location, either under the dash or
in the dash. Make sure that there is adequate depth for the HF7BEQ.
2. Use the mounting brackets and hardware provided. Make sure
there is proper clearance for the mounting bracket screws when
attaching under the dash. Use caution to ensure there are no wiring
harnesses behind the dash panel (where the mounting
screws are fastened).
3. Route the power, ground, and remote wires away from moving
parts to prevent pinching or shortened wires.
WIRING
1. Power Wire: The power wire should connect to a constant or
switched +12 volt source with a (2 Amp) in-line fuse. We recommend
that you use the radio constant or switch +12 volt source.
2.Gound Wire: Connect the ground wire to a clean chassis ground
point. Be sure to remove all paint and primer to expose clean metal.
Use a ring terminal and lock or star washer to secure the ground wire.
3. Remote Wire: The remote wire should be connected to the source
until remote or antenna wire that provides +12 volts when the
source unit is "on" and 0 volts when the source unit is turned "off."
Prior to mounting, connect the wires
to ensure proper operation.
2
Advertisement
