Advertisement
CAUTIONS
1.Before installing the controller, please check if the main power is turned off.
2.Before supplying power, please check if the power switch is selected properly.
3.Aviod installing the controller in a high humid environment to prevent failure.
4.The relay outputs shall be used within the operating limit of the controller as the
specification.
5.Read this instruction carefully to prevent any damage cause by misused will void
the warranty.
SET THE CONTROLLER
Command only by cordless remote
Operating mode allow selection from four modes of operation(COOL/HEAT/FAN/
DEHUM.)
Setting range Cooling mode 16
Fan
allow selection from three speeds or/and auto-fan
Sleep mode available in cooling and heating mode.
Swing control allow to select five different angle of fan outlet louver or swing.
apply to 5-wire/6-wire step motor)
Auto-on Auto-off timer 1 12 hrs.
Power button The power button is on the receiver panel which is used to turn
on/off the power directly in case of a failure of cordless remote
this button to turn on the controller, the operating function will remain
the last setting
4-Way control 4-way relay contact only closed in heating mode.
FUNCTION
Cooling When room temp.
Set temp., Green LED on and compressor on.
Green LED flashes while compressor delay protection) When room temp.
Set temp.
2 , green LED flashes and compressor off.
Heating When room temp.
Set temp., Red LED on and compressor on.
( Red LED flashes while compressor delay protection
Set temp.
2 , red LED flashes and compressor off.
Fan If select continuous fan, green LED flashes.
Dehumidifying If select dehumidifying, compressor on 10 min. And off 10 min. In cycle
with low speed fan. When the room temperature is under 16
compressor continuously off.
Sleep
After one hour of setting sleep mode, the set temp. will rise 1
cooling mode.
Reduse 1
sleep mode, the set temp. will rise another 1
Reduse another 1
in heating mode). The max. set temp. is 30
set temp. is 16
Auto-on/off timer The auto-on/off timer counts once the setting is finished.
Receiver
45
7M
45
-Version 01
30
; Heating mode
16
32 .
When room temp.
automatically in
in heating mode
. After two hours of setting
and remain the latest set temp.
; the min.
RECEIVER
LED
POWER BUTTON
WIRING
Press
Outdoor unit
AC110V
220V 10
SPECIFICATION
Power supply AC110V AC220V 10 , Single phase 50Hz 60Hz
,
Reading range 5
Relay outputs compressor output 25A 250VAC
SW2 selection (Only apply to DEI-737C)
1. ON with three minutes delay protection ; OFF without three minutes
delay protection
2. ON Continuously Fan Defult ; OFF Fan active as 3-way valve.
Sepcial option
J
2
Short Step motor set on the right. Defult
Open Step motor set on the left. Remove the jumper
ERROR
If sensor fail , red LED flashes rapidly.
If interval sensor fail, orange LED flashes rapidly. Return the goods back to factory
AC110V
220V 10
Indoor unit
FAN
MOTOR
LOW
MAIN1
AC1
CN4
J2
CN5
Connect to receiver
Connect to step motor(bule wire on the left side)
Indoor unit
FAN
MOTOR
MAIN1
LOW
MID
AC1
J2
CN4
CN5
Connect to receiver
Connect to step motor(bule wire on the left side)
45
1
fan speeds outputs 3A 250VAC 3
4-way output
3A
250VAC
Defult
Check the connection
OUTDOOR
POWER SUPPLY
Outdoor unit
HI
MID
INDOOR
POWER SUPPLY
HI
Advertisement
