Table of Contents
Advertisement
Simplified Self-Diagnostic System facilitates finding the cause of the fault. The following data
will be displayed on the TV screen.
The Error Code data is stored in the Memory IC (IC6004) (latest error only). This data is cleared
after it is displayed, and then the POWER button is pressed back on.
1. With power turned off, press FF and REW buttons on the unit
together for over 3 seconds.
2. TV power comes on and the unit goes into service mode.
The following codes will be displayed.
Note:
Press any operation button except for POWER on either the unit,
or the remote to detecet that a key has been pressed. The 3rd digit
changes to "1" only when key is detected.
Fig. 1-1
Fig. 1-2
Fig. 1-3
9
Advertisement
Table of Contents
