Toro 78463 Operator's Manual page 21

Figure 30
Installing the tension spring and aligning the belt
1. Blower assembly
2. Latch pin (locking position) 7. Idler-spring post
3. Chute bracket
4. Idler-pivot bracket
5. Fixed spring post
3. Move the idler-pivot bracket toward the fixed
spring post and install the spring by aligning the
spring hook onto the idler-spring post
30).
Note:
Ensure that the spring hooks are
positioned correctly on the spring posts.
4. Pull the spring-loaded idler pulley away from the
fixed spring post, and route the belt around the
deck pulley (Figure
Note:
Ensure that the belt is correctly routed
around the blower pulley.
5. Install the blower-belt cover over the blower belt
and secure the blower-belt cover with the belt
knob (Figure 31).
6. Spring
8. Spring (hook end)
9. Belt (aligned to the idler
pulley)
(Figure
30).
1. Cover knob
g018371
21
Figure 31
2. Blower-belt cover
g341601