Table of Contents
Advertisement
Fault
flashes.
lights up.
flashes.
All other error codes.
"E:30/-20"
The appliance is not
working.
The programme does
not start.
Cause and troubleshooting
Voltage under-usage may cause extension of a pro-
gramme.
No remedial action possible.
The temperature is too high.
Wait until the temperature has dropped.
▶
→ "Cancelling the programme", Page 31
▶
Water level is too high.
Select a suitable programme for draining.
▶
→ "Programmes", Page 24
Door is not closed.
Close the door.
1.
Press
to start the programme.
2.
Laundry is caught in the door.
Open the door again.
1.
Remove any trapped laundry.
2.
Close the door.
3.
Press
to start the programme.
4.
Malfunction
Call the after-sales service.
▶
→ "Customer Service", Page 49
Solenoid valve defective.
Call the after-sales service.
▶
→ "Customer Service", Page 49
Detergent dosage is too high.
Reduce the amount of detergent for the next wash-
▶
ing cycle with the same load.
Additional water is added.
Do not add any extra water to the appliance while it
▶
is operating.
The mains plug of the power cord is not plugged in.
Connect the appliance to the power supply.
▶
The circuit breaker in the fuse box has tripped.
Check the circuit breaker in the fuse box.
▶
There has been a power cut.
Check whether the lighting in your kitchen or other
▶
appliances are working.
You have not pressed
Press
.
▶
Door is not closed.
Troubleshooting en
.
41
Advertisement
Table of Contents
