Faults
The programme duration
is longer than usual.
The programme duration
changes during the wash
cycle.
Residual water in the
compartment i for care
products.
Odours in the washing
machine.
The N symbol flashes in
the display panel. Foam
may escape from the
detergent drawer.
Intense noise, vibrations
and "wandering" during
spinning.
Display panel/indicator
lamps do not function dur-
ing operation.
Detergent residues on the
laundry.
NO appears on the dis-
play panel in reload
mode.
YES appears on the dis-
play panel in reload
mode.
The colon in the "Ready
in" display (:) flashes on
the display panel.
The single dot (.) flashes. The undervoltage has caused the wash programme to be extended.
If you cannot correct a fault yourself (after switching off/on) or a repair is required:
Set the programme selector to Off. The appliance is switched off.
■
Unplug the mains plug from the socket.
■
Turn off the tap and call the after-sales service .
■
Cause/remedial action
Not a fault – the unbalanced-load detection system is adjusting the imbal-
■
ance by repeatedly distributing the laundry.
Not a fault – the foam detection system active – adds an additional rinse
■
cycle.
Not a fault – the programme sequence is optimised for the particular washing
process. This may lead to changes in the programme duration in the display
panel.
Not a fault – the effect of the care product is not affected.
■
Clean the insert if necessary.
■
Run the i Cottons 90 °C programme without laundry.
Use standard detergent.
Too much detergent used?
Mix one tablespoon of fabric softener with 1/2 litre water and pour into com-
partment II (not for outdoor fabrics, sportswear fabrics or those made with
down).
Reduce the detergent dosage for the next wash cycle.
Is the appliance levelled? Level the appliance.
■
Are the appliance feet fixed? Secure the appliance feet.
■
Transport locks removed? Remove the transport locks.
■
Power cut?
■
Circuit breakers tripped? Switch the circuit breakers back on or replace
■
them.
If the fault occurs repeatedly, call the after-sales service.
■
Occasionally, phosphate-free detergents contain water-insoluble residues.
■
Select O Rinse or brush the laundry after washing.
■
Water level too high. Not possible to add laundry. Close the washing
■
machine door immediately, if necessary.
To continue the programme, press Start/Pause A.
■
The washing machine door is unlocked. It is possible to add laundry.
The mains voltage is too low.
Faults and what to do about them.
en
29