Panasonic NA-S106X1 Operating & Installation Instructions Manual page 36

Troubleshooting
Problem
Fabric softener
There is powdered
detergent left on
the laundry after
washing
There is an
unusual noise or
vibration
There is noise
when water drains
out
There is a fan
rotation sound.
When power cut
occurs
A circuit breaker
trips the electricity
supply
The water supply
is disrupted
The display is
unclear
36
(continued)
Cause and Measures
- The amount of softener used may have been above the
"MAX" line in the detergent drawer. (P. 12)
- The detergent drawer may have been closed too
strongly and spilt some of the softener.
- Powdered detergent may have been put directly into
the drum.
It should be put into the detergent drawer. (P. 12)
- There may be a metal item in the drum.
- The anchor bolts may not have been removed.
( P. 41)
- The appliance may be installed on a slope or an
unstable surface.
- Wet clothes may be loaded at the start of washing.
Perform spin process or wring out the laundry
beforehand.
- This is normal. It is the noise of the drain pump
working.
- This is normal. The fan cools electric parts.
- The appliance stops running. Even if the power supply
is recovered, the appliance will not run again. Switch
on the power and restart the appliance.
- The appliance stops running. After the circuit breaker is
reset, the appliance will not run again. Please identify
the cause of circuit breaker causing the power supply
interruption, and solve the problem. Afterwards, reset
the circuit breaker, reswitch on the power and restart
the appliance.
- After the water supply is restored, the water may be
discoloured for a short while.
Disconnect the water supply hose, run the tap until
the water is no longer discoloured, and reconnect the
water supply hose. (P. 43)
- The appliance may be in a brightly lit or sunlit area.