Fagor 3FE-7414IT Instruction Manual page 94

Temperature selection button
6
The button
grammes.
When pushing the button
settings or cold water options (without preheating) for the relevant wash pro-
gramme. Depending on the selected wash programme, the display shows the
following setting options: - -°C (cold) - 20°C - 30°C - 40°C - 60°C - 90°C.
Spin speed button
7
Button
in order to change the setting. Depending on the selected wash programme, the
display shows the following values - 0 (no spin) - 400 - 600 - 800 - 1000 - 1200 -
1400.
Function selection button
8 The multifunction button can be one of two functions (extra rinse or pre-wash) or
both functions can be selected simultaneously. If this function is started, the LED
above the symbol of the selected function lights up.
Attention! The functions Extra Rinse/Prewash and are not available for all washing
programs (see: Program table).
Pre-wash
The pre-wash function prolongs the washing time by about 20 min. The main wash
is then preceded by an additional wash cycle at a temperature of 30°C.
With the pre-wash function very good washing results can be achieved without
previously soaking the laundry. This function is recommended for heavily soiled
laundry.
Attention! Before starting the pre-wash function, you have to put detergent in the
Extra Rinse
The Extra Rinse function is especially recommended for underwear and for clothes
of people with sensitive skin. This function consists in an additional rinse of the
laundry.
6+7 Child lock
6+7
The child lock blocks the function buttons, so that children cannot inadvertently
change the settings. In order to activate the child lock during the washing, push
the buttons
hold them for about 3 seconds. In order to deactivate this function during the wash
cycle, again push the same buttons and hold them for about 3 seconds.
Note 1: When the child lock is activated, the display shows the symbol
Note 2: The lock is not automatically deactivated at the end of the wash pro-
gramme.
94
6
serves to set the temperature for the respective washing pro-
6
, the display shows the available water temperature
7
serves to set the spin speed during the pumping cycle. Push the button
detergent dispenser with the symbol "
6
(Temperature selection) and
".
7
(Spin speed) simultaneously and
.