Table of Contents
Advertisement
Install your oven by following three simple steps:
1. Remove all packing materials and accessories.
2. Place the oven in the level location of your choice with more than 85cm height but make sure there is at least
10 cm of space on the top and 10cm at the rear for proper ventilation. The side of the oven should be kept clear
so there is air flow for ventilation.
An exhaust outlet is located on top or side of the oven. Blocking the outlet can damage the oven.
3. Plug your oven into a standard voltage household outlet. Be sure the electrical circuit is at least 13 amps
and that your microwave oven is the only appliance on the circuit.
NOTE: • If your oven does not operate properly, unplug it from the AC household outlet and then
plug it back in.
• This appliance should not be used for commercial catering purposes.
WARNING : THIS APPLIANCE MUST BE EARTHED
The wires in the mains lead are coloured in accordance with the following codes :
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured
markings identifying the terminals in your plug, proceed as follows :
The wire which is coloured blue must be connected to the terminal which is marked with the letter
N or coloured black.
The wire which is coloured brown must be connected to the terminal which is marked with the
letter L or coloured red.
The wire which is coloured green & yellow must be connected to the terminal which is marked
with the letter E or
.
This utility article is provided with a mains cord of special performance, which in case it is damaged, must be
replaced with a mains cord of the same type ; such a mains cord can be obtained from importer and be
installed by a competent person.
Installation
IMPORTANT
Blue
- Neutral
Brown
- Live
Green & Yellow
- Earth
5
Advertisement
Table of Contents
