Ningbo SK-5801 User Manualr

SK-5801
Remote Controlled RF Socket
USER GUIDER
Set-up
Insert the battery into the battery compartment of the remote control making sure polarity
is correct.
For first use
Plug the socket into a main or wall socket,the LED will flash once per second (under
learning code situation).Point the remote at the socket and hold down one of buttons of
ON or OFF on the remote(1,2,3or4) until the LED flashes continuously in 2 seconds.And
then the LED flashes once per second,that means the code was successfully learned by
socket,the socket has memorized the code.Then press ON or OFF button which is
chose,the socket works.
For advanced use
Under off situation,press ON/OFF switch on the socket last for 3 seconds or hold down the
OFF button on the remote of which channel has learned code continuously for 3
seconds.Then the LED flashes once per seconds,that means the socket turns into
learning situation.In this moment,it can learn another remote code.
ATTENTION: All RF receivers(socket,switch,connecting box,lamp holder) can be
controlled by more than one remote.Under learning code situation,the receiver can
learn more than one remote's codes.
Adapted Transmitter: T-03,T-05,T-06
To operate
Plug a lamp(or other electric device)into the socket and switch on the lamp.Then for on or
off press the correct ON or OFF button just once.
Trouble shooting
If remote control will not operate RF socket-
1. The battery power may be low and the battery may be replacing.
2. The remote is too far away from the socket-move closer and try again.
3. The code is not learned successfully.
Clearing codes
In off situation, hold down the OFF button on the remote of which channel has learned
code continuously for 3 seconds.Then the LED flashes once per second(under learning
code situation),and hold down ALL OFF button continuously for 3 seconds.When the LED
flashes from quickly to once per second,that means clearing code is successful.
Alternatively-