Dear customer, Thank you for having chosen our induction ceramic hob. In order to make the best use of your appliance, we would advise you to read carefully the following notes and to keep them for a later consulting. SUMMARY SAFETY ............................
SAFETY Precautions before using Unpack all the materials. The installation and connecting of the appliance have to be done by approved specialists. The manufacturer cannot be responsible for damage caused by installation or connection errors. To be used, the appliance must be well-equipped and installed in a kitchen unit and an adapted and approved work surface.
In general do not place any metallic object except heating containers on the glass surface. In case of untimely engaging or residual heat, this one may heat, melt or even burn. Never cover the appliance with a cloth or a protection sheet. This will become very hot and may catch fire.
Precautions in case of appliance failure If a defect is noticed, switch off the appliance and turn off the electrical supplying. If the ceramic glass is cracked or fissured, you must unplug the appliance and contact the after sales service. ...
2100 W 2600 W 3700 W Rear left 220x180 mm 2100 W 2600 W 3700 W H902B 11100 W Middle Ø260 mm 1850 / 2600 W 2500 / 3300 W 3000 / 5500 W Rear right 220x180 mm 2100 W...
USE OF THE APPLIANCE Display Display Designation Description Zero The heating zone is activated. 1…9 Booster level Selection of the cooking level. No pan detection No pan or inadequate pan. Heat accelerator Automatic cooking. Error message Electronic failure. Residual heat The heating zone is hot.
Power selection zone “SLIDER” and timer setting zone To select the power with the slider, slide your finger on the “SLIDER” zone. You can already have a direct access if you put your finger directly on the chosen level. Power selection zone “SLIDER” and timer setting zone “SLIDER“...
Residual heat indication After the switch off of a heating zone or the complete stop of the hob, the heating zones are still hot and indicates [ H ] on the display. The symbol [ H ] disappears when the heating zones may be touched without danger. As far as the residual heat indicators are on light, don’t touch the heating zones and don’t put any heat sensitive object on them.
To stop the cooking time: Action Control panel Display Select the Timer Press simultaneously key [ - ] and [ + ] Timer display on from the timer until the desired display is on Stop the time Press key [ - ] from the timer [ 000 ] If several timers are activated, repeat the process.
Recall Function After switching off the hob [ ], it is possible to recall the last settings. cooking stages of all cooking zones (Booster) minutes and seconds of programmed cooking zone-related timers Keep warm function Automatic cooking The recall procedure is following: ...
COOKING ADVICES Pan quality Adapted materials: steel, enamelled steel, cast iron, ferromagnetic stainless-steel, aluminium with ferromagnetic bottom. Not adapted materials: aluminium and stainless-steel without ferromagnetic bottom, cupper, brass, glass, ceramic, porcelain. The manufacturers specify if their products are compatible induction. To check if pans are compatibles: ...
The control panel displays [ Er47 ] : The hob is not connected to the network. Check the connection and reconnect the hob. If one of the symbols above persists, contact Award Appliances. ENVIRONMENT PRESERVATION The materials of packing are ecological and recyclable.
INSTALLATION INSTRUCTIONS The installation comes under the exclusive responsibility of specialists. The installer is held to respect the legislation and the standards enforce in their home country. How to stick the gasket: The gasket supplied with the hob avoids all infiltration of liquids in the cabinet. His installation has to be done carefully, in conformity of the following drawing.
ELECTRICAL CONNECTION The installation of this appliance and the connection to the electrical network should be entrusted only to a suitably qualified service agent perfectly to the fact of the normative regulations and which respects them scrupulously. Protection against the parts under tension must be ensured after the building-in. ...
Page 17
Caution! Be careful that the cables are correctly engaged and tightened. Award cannot be held responsible for any incident resulting from incorrect connection or which could arise from the use of an appliance which has not been earthed or has been...
Page 20
Award Appliances (NZ) Limited E-mail: sales@award.co.nz www.awardappliances.co.nz 22891-1...
Need help?
Do you have a question about the H902B and is the answer not in the manual?
Questions and answers