JVC AV-56WP74 Service Manual page 15

2.7.14 AV TERMINAL BOARD
• Take out the REAR PANEL
(1) Remove 9 screws [ T ].
(2) Remove 1 screws [ U ].
(3) Pull out the POWER CORD CLAMP from AV TERMINAL
BOARD left side.
(4) Remove the nut [ V ] attaching the ANTENNA TERMINAL.
(5) Take out the AV TERMINAL BOARD.
2.7.15 DIGITAL INPUT MODULE
• Take out the REAR PANEL
(1) Remove 2 screws [ W ] from rear side of the AV TERMINAL
BOARD.
(2) Take out the DIGITAL INPUT MODULE.
NOTE :
• When removing the DIGITAL INPUT MODULE, refer to
the "CAUTION AT DISASSEMBLY" section on page 11.
2.7.16 MAIN CHASSIS
• Take out the REAR PANEL.
• Take out the AV TERMINAL BOARD.
• Take out the LINE FILTER BRACKET.
(1) Remove 2 screws [ X ] both side of the MAIN CHASSIS.
(2) Remove 1 screws [ Y ] attaching the earth wire.
(3) Remove 1 screw [ P ] attaching the MAIN CHASSIS and
BODY.(Fig.7)
(4) Pull out the MAIN CHASSIS for back side.
NOTE :
• If necessary, remove the anode wires, connectors,
respectively.
W
DIGITAL INPUT
MODULE
V
ANTENNA TERMINAL
POWER CORD
CLAMP
Fig.9
X
MAIN CHASSIS
X
Fig.10
AV-48WP74
AV-56WP74
AV TERMINAL
BOARD
U
T
POWER CORD
EARTH WIRE
Y
(No.52105)1-15