Table of Contents
Advertisement
Figure. 7
1. Adding Hydraulic Oil
a. Place the Mower on a level surface and
engage the parking brake.
b. Stop the engine and remove the key
from the ignition switch.
c.
Clean the area around the Hydraulic Oil fill
neck.
d. Remove the hydraulic fill cap and check
the level. The correct level is up to the low-
est hole of the oil tank fill neck.
e.
Pour hydraulic oil into the reservoir up to
the lowest hole in the oil tank fill neck, if
necessary.
2. Draining Hydraulic Oil
Used hydraulic oil must be disposed of properly. Do not
pour it down a drain or sewer, or dump it on open land, this
creates an environmental hazard. Please be aware of the
environment when disposing of used oil.
a. Place the Mower on a level surface and
engage the parking brake.
b. Stop the engine and remove the key from
the ignition switch.
c. Remove the mower deck. See section on
Mower Deck.
d. Raise the seat forward to expose the
hydraulic oil fill point.
e. Clean the area around the hydraulic fill oil
cap.
f.
Remove hydraulic fill oil cap.
g. Place a suitable container (at least 2
quarts) under the hydraulic reservoir and
filter.
h. Remove the hydraulic filter to allow hydrau-
lic oil to drain. Remove the drain plug from
the bottom of the hydraulic oil tank to drain.
Replace the plug.
i.
Place a small pan under the pump motor
frame. Remove fill oil cap from hydraulic
reservoir for faster drainage. Remove nut
Hydraulic Tank
(5W40 full synthetic)
caps and drain oil from both left and right
pumps. Replace and retighten nuts.
Hydraulic pumps
Unfasten hose and drain from
this side of both pumps.
j.
Coat new filter seal with oil before installa-
tion. Install new hydraulic oil filter filled with
new oil.
k. Add proper amount of hydraulic oil to res-
ervoir.
l.
Run and purge gearboxes. Check oil level.
m. Add proper amount of hydraulic oil to res-
ervoir and repeat step L.
C.Electrical Circuit
Read General Safety Precautions Nos. 9 and 10.
1. Battery: The battery is located beneath the
operator's seat. To keep the outside of the
battery clean, brush on a strong solution of
bicarbonate of soda and water and rinse with
clean water. Keep the contacts and cable
ends clean with a wire brush and make sure
the connections are tight. Coat the terminals
with petroleum jelly to prevent corrosion.
2. Battery Storage: When storing the Mower for
long periods of time the following guidelines
should be taken.
a. Disconnect the battery cables from the ter-
minals and remove the battery. You will
have to remove the control panel to access
the battery strap. Replace control panel.
b. Clean the battery before storing. A dirty
battery will lose its charge over time.
18
Figure. 8
Danger:
Advertisement
Table of Contents
