Error Display - Panasonic NA-148VG4 Operating Instructions & Installation Instructions

Unable to drain
Door is open
Unable to spin-dry
Unable to supply
NA-140_168_148VG4_WGB_En.indb
Downloaded from www.Manualslib.com
What to do
Check the drain hose for any of following problems.
- It clogs up.
- Its tip is immersed in water.
- It extends further than 3 m.
- The water is frozen.
Clean the drain filter if it clogs up. (See page 27.)
After correcting the problem, open the door, close it, and then
start the wash again.
What to do
Make sure that the door is shut properly.
The appliance has been designed to detect unbalanced loads,
especially small loads, in order to ensure quiet operation and
achieve the best results.
This is not a malfunction. Perform any one of the following
solutions.
What to do
- If the laundry is too heavy, untangle clumps of clothing.
- If the laundry is too heavy because items, such as blankets, are
too large, reduce the load.
- If the laundry is too light, add one or two bath towels.
- If the appliance is on an unstable or uneven surface, change
the setting location.
After correcting the problem, open the door, close it, and then
start the wash again.
What to do
Check for any of following problems.
- The tap is closed.
- The water pipe or hose is frozen.
- The water supply has been disrupted.
- The water-supply filter is clogged. (See page 28.)
After correcting the problem, open the door, close it, and then
water
start the wash again.
If the red mark appears in the hose with water-supply valve, it
have been stop the water supply.
You should replace with a new hose.
Hose with water-supply valve (No.AXW12C-7SR0)
An error display starting with H.
What to do
Press the Off button. If the display stays on, or if it reappears
when you press the Start button, unplug the appliance and
contact your local Customer Communications Centre.
33
manuals search engine

Error Display

Troubleshooting - 33
2013/08/05 13:13:01