Cleaning And Care - Bosch DWK09M760B Operating Instructions Manual

The charcoal filter can be washed once
every two months (or when the filter
saturation indication system – if envisaged
on the model in possession – indicates this
necessity) using hot water and a suitable
detergent, or in a dishwasher at 65°C (if the
dishwasher is used, select the full cycle
function and leave dishes out).
Eliminate excess water without damaging the
filter, then put it in the oven for 10 minutes at
100° C to dry completely. Replace the
mattress every 3 years and when the cloth is
damaged.
❑ The activated carbon filters are available
from specialist outlets (see Optional
accessories).
❑ Use only original filters. The appliance
is then guaranteed to function perfectly.
Disposal of old activated carbon filters:
❑ Activated carbon filters do NOT contain
any harmful substances. They can
therefore be disposed of as householder
fuse.
34

Cleaning and care

Disconnect the extractor hood from the
electricity supply by pulling out the mains
plug or switching it off at the fuse box.
❑ At the same time as you clean the grease
filters, clean off any grease from all
accessible parts of the housing. This
significantly reduces the fire hazard and
ensures that the extractor hood performs
as effectively as possible.
❑ Use a hot detergent solution or a mild
window cleaner to clean the canopy of the
extractor hood.
❑ Do not scrape off any dirt that has dried
on but loosen it up with a damp cloth.
❑ Do not use abrasive cleaning agents or
sponges that could cause scratches.
❑ Note: Do not use alcohol (spirit) on
plastic parts, otherwise the surface may
become matt in appearance.
Caution: Ensure that the kitchen is
adequately ventilated. Avoid naked
flames!
Clean the sliding switch with a soft,
damp cloth (mild detergent solution) only.
Do not use stainless steel polish on the
sliding switch.
Stainless steel surfaces:.
❑ Use a mild non-abrasive stainless steel
cleaner.
❑ Clean the surface in the same direction
as it has been ground and polished.
Do not use any of the following to clean
stainless steel surfaces: abrasive sponges,
cleaning agents containing sand, soda, acid
or chloride!
Aluminium and plastic surfaces:
❑ Use a soft, non-linting window cloth or
micro-fibre cloth.
❑ Do not use dry cloths.
❑ Use a mild window cleaning agent.. Do
not use aggressive, acidic or caustic
cleaners.
❑ Do not use abrasive agents.