Installing The Turbocharger - ABB HT591736 Operation Manual

Operation Manual / TPL67-C.. - TPL71-C..
7 Removal and installation / 7.3 Installing the turbocharger

7.3 Installing the turbocharger

© Copyright 2019 . All rights reserved.
Remove the cover from the oil connection.
u
Inspect the lifting gear.
u
Fasten a separate lifting gear to each of the two ribs on the bearing
u
casing provided for this purpose.
CAUTION
Oil orifice plates
An orifice plate for adjusting the oil pressure is fitted in each of the two
oil inlet channels in the bearing casing. When the cartridge group, the
bearing casing or the turbocharger is fitted to the engine, it must be
ensured that the orifice plates that are specified for the turbocharger
have been installed in the two oil inlet channels.
Check correct installation of oil orifice plates.
u
Fit the turbocharger to the engine.
u
Tighten the fixing screws at the foot in accordance with the engine
u
builder's instructions.
Fasten the gas, air and oil lines in accordance with the engine
u
builder's instructions.
Version with compressor wheel cooling system
Fit the air supply line (also see the chapter entitled Preliminary re-
u
marks / Layout and functioning).
Refit the parts of insulation which had been removed.
u
Plug in the cable connector on the speed sensor.
u
HZTL2488_EN Revision F April 2019