Table of Contents
Advertisement
Remote Control
Install the batteries
Use batteries type UM3 (AA-Size).
Do not use old or weak batteries. The remote control may not work properly with a weak voltage from such
batteries. Replace exhausted batteries with new ones. Never try to recharge normal batteries - this could
cause an explosion.
Note:
•
Exhausted batteries can leak corrosive electrolyte, which may cause damage to the remote
control - therefore remove exhausted batteries immediately.
•
Batteries should not be exposed to excessive heat such as sunshine, fire or the like.
1
Open the battery
compartment.
Distance of Remote Control Operation
directly at the remote sensor.
The remote control handset will not work properly in the following cases:
a) If bright sunlight directly beams onto the unit front. b) If an obstacle is placed between the unit and the
c) If the batteries have not been installed according
to their polarities.
If this symbol is shown, it is only valid in the
European union.
2
Install the batteries as shown
below, ensuring the correct
polarity.
Point the remote control
3
Maximum distance approx. 5m
30
30
handset.
d) If the batteries are weak.
Close the battery
compartment.
Remote sensor
Transmitter window
7
Advertisement
Table of Contents
