Antenna / Cable Service Without A Box; Initial Setting - Panasonic TC-65FZ1000C Ehelp

Antenna / Cable service without a box

Initial setting

Depending on the model, it may be necessary to remove the terminal
●
cover / cable cover before connecting or disconnecting cables.
1. Connect coax
Connect a COAX wire from either an Antenna or Basic Cable service to
the TV's "ANTENNA/CABLE IN" screw terminal.
TV (ANTENNA/CABLE IN)
Antenna
2. Scan the channel
MENU Menu
Cable signal, Auto program
1) Select either Cable or Antenna programming source in
Cable signal.
2) Select Auto program
(All channels
3) Start scanning.
The tuner setup menu (auto scan, etc.) is only available when INPUT is
●
set to TV.
If no channels are found by the end of the scan, then check the
●
following:
– Antenna's position - or availability of Cable service.
– Cable, Satellite or Fiber Optic services with a box are typically
connected to the TV's A/V inputs, preferably HDMI, for best HD
picture. In such case, the channel scanning is not needed.
> Setup > ANTENNA/Cable setup
and then the appropriate scan mode:
Analog only Digital
/ /
- 29 -
> ANTENNA/
ANTENNA/
only)