Battery Fighter BCA1102S6WR Instruction Manual

Intelligent battery charger for both 6v & 12v lead acid automotive batteries

Advertisement

Quick Links

INSTRUCTION MANUAL
THIS MANUAL CONTAINS IMPORTANT SAFETY AND OPERATING INSTRUCTIONS. PLEASE SAVE THESE
INSTRUCTIONS. KEEP WITH OR NEAR CHARGER AT ALL TIMES.
WARNING – RISK OF EXPLOSIVE GASES.
1.
a.
Working in the vicinity of a lead-acid battery can be dangerous. Batteries generate explosive
gases during normal battery operation.
b.
For this reason it is of the utmost importance that prior to each use of your charger, you read and
follow the instructions provided exactly:
c.
The appliance is not intended for use by young children or infirm persons without supervision.
Young Children should be supervised to ensure that they do not play with the appliance.
2.
To reduce risk of a battery explosion, follow these instructions and those marked on the battery.
3.
NEVER smoke or allow an open spark or flame in the vicinity of the battery or engine.
CAUTION – To reduce the risk of injury, use the charger for charging a rechargeable lead-acid battery only. It is not
4.
intended to supply power to a low-voltage electrical system or to charge dry-cell batteries. Charging dry-cell
batteries may cause them to burst and cause injury to persons and damage to property.
5.
Do not expose the charger to moisture, rain or snow. For indoor use only.
6.
Use of an attachment not recommended or sold by the battery charger manufacturer may result in a risk of fire,
electric shock, or injury to persons.
7.
To reduce risk of damage to electric plug and cord, pull by plug rather than cord when disconnecting the charger.
8.
Make sure cord is located so that it cannot be stepped on, tripped over, or otherwise subjected to damage or stress.
Study all the battery manufacturers' specific precautions such as removing or not removing cell caps while charging
9.
and recommended rates of charge.
10. Do not use the battery charger unless the battery voltage matches the output voltage rating of the charger.
11. Do not operate the charger in a closed-in area or restrict ventilation in any way.
12. An extension cord should not be used unless absolutely necessary. Use of improper extension cord could result in a
risk of fire and electric shock. If extension cord must be used, make sure:
a.
That pins on the plug of extension cord are the same number, size and shape as those of plug on charger;
b.
That extension cord is properly wired and is in good electrical condition;
c.
That wire size is as specified below.
Length of Cord (Feet)
AWG Size of Cord
13. Do not operate the charger with damaged cord or plug. If the supply cord cannot be replaced and the cord is
damaged, the appliance should be scrapped.
14. Do not operate the charger if it has received a sharp blow, been dropped, or otherwise damaged in any way. Take it
to a qualified repair station or local dealer.
15. Do not disassemble the charger. Take it to a qualified repair station or local dealer when service or repair is required.
Incorrect reassembly may result in a risk of electric shock or fire.
16. To reduce risk of electric shock, unplug the charger from an outlet before attempting any maintenance or cleaning.

PERSONAL PRECAUTIONS:

a.
Someone should be within range of your voice or close enough to come to your aid when you work near a lead-acid
battery.
b.
Have plenty of fresh water and soap nearby in case battery acid contacts skin, clothing, or eyes.
c.
Wear complete eye protection and clothing protection. Avoid touching eyes while working near battery.
d.
If battery acid contacts skin or clothing, wash immediately with soap and water. If acid enters an eye, immediately flood
BCA1382S6WR - 140728
25'
50'
100'
150'
18
18
18
16

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the BCA1102S6WR and is the answer not in the manual?

Questions and answers

Summary of Contents for Battery Fighter BCA1102S6WR

  • Page 1 INSTRUCTION MANUAL THIS MANUAL CONTAINS IMPORTANT SAFETY AND OPERATING INSTRUCTIONS. PLEASE SAVE THESE INSTRUCTIONS. KEEP WITH OR NEAR CHARGER AT ALL TIMES. WARNING – RISK OF EXPLOSIVE GASES. Working in the vicinity of a lead-acid battery can be dangerous. Batteries generate explosive gases during normal battery operation.
  • Page 2 eye with running cold water for at least 10 minutes and get medical attention immediately. NEVER smoke or allow a spark or flame in vicinity of battery or engine. Be extra cautious to reduce risk of dropping a metal tool onto battery. It might spark or short-circuit battery or other electrical part that may cause an explosion.
  • Page 3 Connect the positive (red) clip from the battery charger to the positive (pos, +) post of battery. Position yourself and the free end of cable as far away from battery as possible, then connect negative (black) clip from the battery charger to free end of cable. Do not face battery when making final connection.
  • Page 4 SELECTION FOR BATTERY TYPE A.C. power is connected with the wall socket properly Press MODE button for battery charge mode selection before you connect the charger to the battery terminals. LED Signal Explanation Description 12V 1A Lead Acid charging 12V lead acid battery charge mode at 1A max. 6V 1A Lead Acid charging 6V lead acid battery charge mode at 1A max.
  • Page 5 than 80% and in YELLOW once reaches 80% and will be turned off once fully charged TROUBLE SHOOTING / MESSAGE LIGHTS CHECKLIST: A. Disconnect the charger from the AC outlet. Check connections to battery NO indicator lights are on. and ensure they are good. B.
  • Page 6 9 Stage Lead Acid Charge, Conditioning and Maintenance Process ( 12V Batteries ) Qualification Phase: Initially ensures the battery is in good condition prior to launch of normal charge processes, as a safety measure charge processes will not begin if battery is below 3 volts. Battery Rescue Phase:* Battery Rescue starts if battery voltage has risen unusually high in the early portion of the recharge cycle.
  • Page 7 The battery can be left safely connected to the charger indefinitely. The charger will constantly monitor the battery and “turn-on” again as needed to maintain the battery at a full state of readiness. Technical Specifications: Model: BCA1102S6WR Input: Auto-switching 100V- 240VAC 50/60Hz...
  • Page 8 *Charger Selection and Use Charge and maintenance capacity ranges are suggested only as a guide for battery charger selection and application based on varied customer charging and maintenance requirements. Please be sure to follow safety and use information in user guide for correct product application and use. BCA1382S6WR - 140728...

Table of Contents