Husqvarna 550XP G Mark II Operator's Manual page 25

3. If your product has a special spark arrestor mesh,
clean the spark arrestor mesh weekly.
4. Replace a damaged spark arrestor mesh.
CAUTION:
is blocked the product becomes too hot
and this causes damage to the cylinder and
piston.
™
AutoTune
Your product has the AutoTune
the carburetor automatically, which gives the best
possible adjustment. AutoTune
to weather conditions, altitude, gasoline and the type of
two-stroke oil.
CAUTION:
correctly, speak to your servicing dealer.
The product adjusts correctly after some
fuelings.
To replace a broken or worn starter
rope
1. Loosen the screws to the starter housing
2. Remove the starter housing.
544 - 009 - 07.02.2022
If the spark arrestor mesh
™
function that adjusts
™
lets the engine adapt
™
If AutoTune does not work
3. Pull out the starter rope approximately 30 cm/12 in
and put it in the notch on the pulley.
4. Let the pulley rotate slowly rearward to release the
recoil spring.
5. 545 Mark II, 545G Mark II: Remove the center screw
(A), sleeve (B) and spring (C).
WARNING:
when you replace the return spring or
the starter rope. The recoil spring is in
tension when it is wound up in the starter
housing. If you are not careful, it can
eject and cause injuries. Use protective
glasses and protective gloves.
6. Remove the used starter rope from the handle and
the pulley.
7. Attach a new starter rope to the pulley. Wind the
starter rope approximately 3 turns around the pulley.
8. Pull the starter rope through the hole in the starter
housing and the starter rope handle.
9. Make a tight knot at the end of the starter rope.
10. 545 Mark II, 545G Mark II: Assemble the spring (C),
sleeve (B) and center screw (A).
A
B
C
To tighten the recoil spring
1. Put the starter rope into the notch in the pulley.
You must be careful
25