Coleman CHT10 Instruction Card

INSTRUCTION CARD
CHT10 3AAA HEADLAMP
IMPORTANT SAFETY INSTRUCTIONS
WARNING: When using electric appliances, basic
precautions should always be followed, including
the following:
1. Keep AAA batteries away from small children. If
swallowed promptly see a doctor and have the
doctor phone (202) 625-3333 collect.
2. Do not install the batteries backwards,
follow the + and - symbols as shown in the
instructions. Do not charge or put in a fire. Do
not mix alkaline, standard, or rechargeable
batteries. Do not mix old and new batteries. The
batteries may explode or leak causing injury.
3. Do not leave discharged batteries in the product
for an extended period of time as this could
permanently damage the product.
4. Replace all batteries at the same time.
SAVE THESE INSTRUCTIONS
TO INSTALL OR REPLACE BATTERIES IN
HEADLAMP
Your new headlamp operates on three "AAA" cell
batteries. For longest life, use alkaline batteries.
1. Use the end of the strap buckle as a "Key"
(Fig. 1), and insert it into the slot of the battery
cover located on the side of the headlamp
(Fig. 2).
2. Remove battery door by rotating
counterclockwise 1/4 turn (Fig. 3).
Note: Battery door is designed to stay attached to the
strap buckle "Key".
3. Remove battery cartridge from headlamp body
by turning on side and shaking gently (Fig. 4).
Note: The cartridge is easily removed if batteries
are installed, but may require additional shaking
if no batteries are in the cartridge.
4. Install three batteries in the correct orientation as
shown on the battery cartridge housing (Fig. 5).
5. Properly align battery cartridge and then re-load
back into the headlamp body (Fig. 6).
6. Properly locate battery door, and then rotate
clockwise 1/4 turn to fully secure (Fig. 7).
7. Remove "Key" from battery door by pulling gently
on the strap buckle.
TO OPERATE HEADLAMP
1. Five lighting modes are available: Red,
White, Low, Medium & High.
2. Operate by pressing the power button on
top of the headlamp. Each cycle of the
power button will advance the headlamp to
the next mode. Operating in the Low and
Medium modes will extend the battery life.
3. This headlamp is designed with two
convenient features.
• To advance instantly to the High mode,
simply press and hold the power button
for 3 seconds.
• The headlamp is powered off with
one click after the headlamp has been
operating in one mode for more than
10 seconds.
4. This headlamp is equipped with a battery
indicator which is located inside the
primary reflector. The battery indicator
provides GREEN, AMBER and RED
indications based on the voltage of the
batteries installed. The battery indicator is
designed to operate for 3 seconds when
the headlamp is powered on or if the light
mode is changed.
• GREEN light indicates normal operation
with several hours of operation available.
• AMBER light indicates battery life
is shortened and battery should be
replaced soon.
• RED light indicates battery life is almost
complete and the batteries should be
replaced immediately. RED indicator will
stay on during operation.
** Battery indicator varies depending on mode.
Battery Meter
Charge de la pile
THINGS YOU SHOULD KNOW
1. Operating time for this light depends
on whether it is run continuously or
intermittently. Intermittent operation
extends the run time of the batteries.
2. LEDs are lifetime light sources and do not
need to be replaced.
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7